• There are no items in your cart

TS 151 010-1 : 12.7.0

Superseded

Superseded

A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

DIGITAL CELLULAR TELECOMMUNICATIONS SYSTEM (PHASE 2+) (GSM); MOBILE STATION (MS) CONFORMANCE SPECIFICATION; PART 1: CONFORMANCE SPECIFICATION (3GPP TS 51.010-1 VERSION 13.6.0 RELEASE 13)

Available format(s)

Hardcopy , PDF

Superseded date

10-02-2019

Language(s)

English

US$97.67
Excluding Tax where applicable

Intellectual Property Rights
Foreword
Modal verbs terminology
Foreword
1 Scope
2 References
3 Definitions, conventions and applicability
4 Test Equipment
5 Testing methodology in general (layers 1, 2, and 3)
6 Reference test methods
7 Implicit testing
8 Measurement uncertainty
9 Format of tests
10 Generic call set up procedures
11 General tests
12 Transceiver
13 Transmitter
14 Receiver
15 Timing advance and absolute delay
16 Reception time tracking speed
17 Access times during handover
18 Temporary reception gaps
19 Channel release after unrecoverable errors
20 Cell selection and reselection
21 Received signal measurements
22 Transmit power control timing and confirmation
23 Single frequency reference
24 Tests of the layer 1 signalling functions
25 Tests of the layer 2 signalling functions
26 Testing of layer 3 functions
27 Testing of the SIM/ME interface
28 Test of autocalling restrictions
29 Testing of bearer services
30 Speech teleservices
31 Test of supplementary services
32 Testing of speech transcoding functions
33 Mobile station features
34 Short message service (SMS)
35 Low battery voltage detection
36 Individual equipment type requirements and
    interworking - special conformance testing
    functions
37 to 39 Void
40 GPRS default conditions, message contents and macros
41 GPRS Paging, TBF establishment/release and
    DCCH related procedures
42 Test of Medium Access Control (MAC) protocol
43 RLC Test Cases
44 Test case requirements for GPRS mobility management
45 Session Management Procedures
46 LLC and SNDCP Tests
47 Dual Transfer Mode
48 to 49 Void
50 EGPRS Default Conditions, Message Contents and Macros
51 EGPRS Paging, TBF establishment/release and
    DCCH related procedures
52 EGPRS Test of Medium Access Control (MAC) protocol
53 Test of EGPRS Radio Link Control (RLC) Protocol
54 to 56 Void
57 EGPRS Dual Transfer Mode
58 Void
58a Latency reductions
58b Downlink Dual Carrier and Downlink Multi Carrier
58c EGPRS
58d EFTA
58e DTR
59 Void
60 Inter-system hard handover from GSM to UTRAN
61-69 Void
70 Location Services
80 Generic Access default conditions, message
    contents and macros
81 GAN Discovery and Registration Procedures
82 GAN CS Domain Procedures
83 GAN PS Domain Procedures
84 GAN Iu Mode Procedures
90 Text Telephony (TTY) Services
Annex 1 (normative) - Reference test methods
Annex 2 - Void
Annex 3 - Protocol implementation information
Annex 4 - Test SIM Parameters
Annex 4A - Test USIM Parameters
Annex 5 - Test equipment
Annex 6 (informative) - E-OTD Accuracy Measurement
        Test Environment
Annex 7 (informative) - General rules for statistical
        testing
Annex 8 - Void
Annex 9 (normative) - GAN certificate
Annex 10 (informative) - Repeated SACCH Layer 1
         Test Method
Annex B (informative) - Change History
History

Defines the technical characteristics and methods of test for Mobile Stations (MS), for the Pan European digital cellular communications system and Personal Communication Systems (PCS) operating in the 400 MHz, 700 MHz, 810 MHz, 850 MHz, 900 MHz, 1800 MHz and 1900 MHz band (GSM 450, GSM 480, GSM 710, GSM 750, T-GSM 810, GSM 850, R-GSM 900, ER-GSM 900, GSM 900, DCS 1800 and PCS 1900), standardized by ETSI Special Mobile Group (SMG).

Committee
3GPP RAN 5
DocumentType
Standard
Pages
6001
PublisherName
European Telecommunications Standards Institute
Status
Superseded

I.S. EN 16062:2015 INTELLIGENT TRANSPORT SYSTEMS - ESAFETY - ECALL HIGH LEVEL APPLICATION REQUIREMENTS (HLAP) USING GSM/UMTS CIRCUIT SWITCHED NETWORKS
BS ISO 26683-2:2013 Intelligent transport systems. Freight land conveyance content identification and communication Application interface profiles
TR 103 265 : 1.2.1 ELECTROMAGNETIC COMPATIBILITY AND RADIO SPECTRUM MATTERS (ERM); DEFINITION OF RADIO PARAMETERS
EN 301 489-50 : 2.1.1 ELECTROMAGNETIC COMPATIBILITY (EMC) STANDARD FOR RADIO EQUIPMENT AND SERVICES; PART 50: SPECIFIC CONDITIONS FOR CELLULAR COMMUNICATION BASE STATION (BS), REPEATER AND ANCILLARY EQUIPMENT; HARMONISED STANDARD COVERING THE ESSENTIAL REQUIREMENTS OF ARTICLE 3.1(B) OF DIRECTIVE 2014/53/EU
EG 202 396-1 : 1.2.4 SPEECH AND MULTIMEDIA TRANSMISSION QUALITY (STQ); SPEECH QUALITY PERFORMANCE IN THE PRESENCE OF BACKGROUND NOISE; PART 1: BACKGROUND NOISE SIMULATION TECHNIQUE AND BACKGROUND NOISE DATABASE
TS 102 936-1 : 1.1.1 ECALL NETWORK ACCESS DEVICE (NAD) CONFORMANCE SPECIFICATION; PART 1: PROTOCOL TEST SPECIFICATION
TR 102 914 : 1.1.1 ELECTROMAGNETIC COMPATIBILITY AND RADIO SPECTRUM MATTERS (ERM); ASPECTS AND IMPLICATIONS OF THE INCLUSION OF RECEIVER PARAMETERS WITHIN ETSI STANDARDS
TS 103 428 : 1.1.1 MOBILE STANDARDS GROUP (MSG); ECALL HLAP INTEROPERABILITY TESTING
TS 103 412 : 1.2.1 MOBILE STANDARDS GROUP (MSG); PAN-EUROPEAN ECALL END TO END AND IN-BAND MODEM CONFORMANCE TESTING; PROSE TEST SPECIFICATION
ES 202 396-1 : 1.6.1 SPEECH AND MULTIMEDIA TRANSMISSION QUALITY (STQ); SPEECH QUALITY PERFORMANCE IN THE PRESENCE OF BACKGROUND NOISE; PART 1: BACKGROUND NOISE SIMULATION TECHNIQUE AND BACKGROUND NOISE DATABASE
10/30214021 DC : 0 BS EN 16062 - INTELLIGENT TRANSPORT SYSTEMS - ESAFETY - ECALL HIGH LEVEL APPLICATION REQUIREMENTS (HLAP)
DIN EN 16062:2015-08 Intelligent transport systems - ESafety - eCall high level application requirements (HLAP) using GSM/UMTS circuit switched networks
EN 301 511 : 12.1.1 GLOBAL SYSTEM FOR MOBILE COMMUNICATIONS (GSM); MOBILE STATIONS (MS) EQUIPMENT; HARMONISED STANDARD COVERING THE ESSENTIAL REQUIREMENTS OF ARTICLE 3.2 OF DIRECTIVE 2014/53/EU
12/30242166 DC : 0 BS ISO 26683-2 - INTELLIGENT TRANSPORT SYSTEMS - FREIGHT AND CONVEYANCE CONTENT IDENTIFICATION AND COMMUNICATION - PART 2: APPLICATION INTERFACE PROFILES
TR 102 627 : 1.1.1 ELECTROMAGNETIC COMPATIBILITY AND RADIO SPECTRUM MATTERS (ERM); SYSTEM REFERENCE DOCUMENT; LAND MOBILE SERVICE; ADDITIONAL SPECTRUM REQUIREMENTS FOR PMR/PAMR SYSTEMS OPERATED BY RAILWAY COMPANIES (GSM-R)
EN 16062:2015 Intelligent transport systems - ESafety - eCall high level application requirements (HLAP) using GSM/UMTS circuit switched networks
UNE-EN 16062:2015 Intelligent transport systems - ESafety - eCall high level application requirements (HLAP) using GSM/UMTS circuit switched networks
BS EN 16062:2015 Intelligent transport systems. ESafety. eCall high level application requirements (HLAP) using GSM/UMTS circuit switched networks
ISO 26683-2:2013 Intelligent transport systems — Freight land conveyance content identification and communication — Part 2: Application interface profiles

ISO 3:1973 Preferred numbers Series of preferred numbers
ISO/IEC 7816-3:2006 Identification cards — Integrated circuit cards — Part 3: Cards with contacts — Electrical interface and transmission protocols
ETR 200028 : 20002 RADIO EQUIPMENT & SYSTEMS (RES) - UNCERTAINTIES IN THE MEASUREMENT OF MOBILE RADIO EQUIPMENT CHARACTERISTICS

Access your standards online with a subscription

Features

  • Simple online access to standards, technical information and regulations.

  • Critical updates of standards and customisable alerts and notifications.

  • Multi-user online standards collection: secure, flexible and cost effective.