SN EN 14872 : 2006

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Classification
5 Requirements and test methods
  5.1 General
  5.2 Tolerances
  5.3 Sharp edges
  5.4 Security of safety-related fasteners
       5.4.1 Security of screws
       5.4.2 Minimum failure torque
  5.5 Crack detection methods
  5.6 Dimensions
  5.7 Protrusions
       5.7.1 Requirement
       5.7.2 Test method
  5.8 Assembly
  5.9 Rear luggage carriers - Provision for lighting
  5.10 Strength under high and low temperature
       5.10.1 General
       5.10.2 Requirement
       5.10.3 High temperature test
       5.10.4 Low temperature drop test
  5.11 Dynamic load tests
       5.11.1 Requirement
       5.11.2 Test method - General
       5.11.3 Vertical test - Test method
       5.11.4 Lateral test - Test method
  5.12 Static load test - Vertical load
       5.12.1 Requirement
       5.12.2 Test method
  5.13 Static load test - Lateral load
       5.13.1 Requirement
       5.13.2 Test method
6 Marking
  6.1 Requirement
  6.2 Durability test
       6.2.1 Requirement
       6.2.2 Test method
7 Instructions
Bibliography

Describes safety and performance requirements for the design and testing of luggage carriers intended for permanent mounting above or adjacent to the wheels of cycles and lays down guide lines for instructions on the use and care of such luggage carriers.