SAE AS4716C
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Gland Design, O-ring and Other Seals
Hardcopy , PDF
English
12-12-2017
11-12-2021
1. SCOPE
2. REFERENCES
3. TECHNICAL REQUIREMENTS
4. NOTES
APPENDIX A - O-RING SQUEEZE CALCULATIONS AND DESIGN CONSIDERATIONS
APPENDIX B - GLAND FILL AND O-RING OCCUPANCY CALCULATIONS AND DESIGN
CONSIDERATIONS IGNORING SWELL AND AT AMBIENT TEMPERATURE
APPENDIX C - GLAND FILL AND O-RING OCCUPANCY CALCULATIONS AND DESIGN
CONSIDERATIONS WITH VOLUME SWELL AT 275 DEGREES F
(135 DEGREES C)
This SAE Aerospace Standard (AS) provides standardized gland (groove) design criteria and dimensions for O-ring seal glands for static and dynamic applications, and other seals
| DocumentType |
Standard
|
| Pages |
51
|
| PublisherName |
SAE International
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
This SAE Aerospace Standard (AS) provides standardized gland (groove) design criteria and dimensions for O-ring seal glands for static and dynamic applications, and other seals.
| SAE AS5781A | Retainers (Backup Rings), Hydraulic and Pneumatic, Polytetrafluoroethylene Resin, Single Turn, Scarf-Cut, For Use in AS4716 Glands |
| SAE ARP5555 | Recommendations for Installation of Seals in Standard Glands |
| ASME Y14.5 : 2009 | DIMENSIONING AND TOLERANCING |
| SAE AS5782A | Retainers (Backup Rings), Hydraulic and Pneumatic, Polytetrafluoroethylene Resin, Solid, Un-Cut, For Use in AS4716 Glands |
| ASME B46.1 : 2009 | SURFACE TEXTURE (SURFACE ROUGHNESS, WAVINESS, AND LAY) |
| SAE AS568D | Aerospace Size Standard for O-rings |
| SAE AS6235A | Face Seal Gland Design, Static, O-ring and Other Seals for Aerospace Hydraulic and Pneumatic Applications |
| SAE AS8791C | Hydraulic and Pneumatic Retainers (Back-Up Rings), Polytetrafluoroethylene (PTFE) Resin |
| MIL-G-5514 Revision G:1993 | Gland Design; Packings, Hydraulic, General Requirements for |
| SAE ARP4727B | Gland Design, Computation of Seal Squeeze and Gland Volume |
| SAE ARP5935 | Use of HVOF Thermal Spray Coatings for Hard Chrome Replacement in Landing Gear Applications |
| SAE AIR6079 | Selection of Metallic Spring Energized Seals for Aerospace |
| ISO 4287-1:1984 | Surface roughness — Terminology — Part 1: Surface and its parameters |
Access your standards online with a subscription
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.
Important note : All end users must be registered with an Account prior to user licenses being assigned.