SAE AS4167C
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Wrenches; Flare Nut, Crowfoot, 12 Point Non-Distorting
Hardcopy , PDF
English
07-06-2016
01-24-2024
1. SCOPE
2. APPLICABLE DOCUMENTS
3. CLASSIFICATION
4. REQUIREMENTS
5. DESIGNATIONS
6. CLASSIFICATION DESCRIPTIONS
7. NOTES
Provides 12 point flare nut crowfoot, flare nut wrenches, double end flare nut wrenches, combination box and flare nut wrenches, and ratcheting flare nut wrenches that are designed with the following requirements: a. Non-distorting usage, b. Possessing the strength, clearances, and internal wrenching design to be used on hydraulic tube fittings that conform to the requirements of SAE J514, c. Transmitting torque to tube fittings without bearing on the apex of fitting wrenching points.
| DocumentType |
Standard
|
| Pages |
17
|
| PublisherName |
SAE International
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
This SAE Aerospace Standard (AS) covers 12 point flare nut crowfoot, flare nut wrenches, double end flare nut wrenches, combination box and flare nut wrenches, and ratcheting flare nut wrenches that are designed with the following requirements: (a) Non-distorting usage; (b) Possessing the strength, clearances, and internal wrenching design to be used on hydraulic tube fittings that conform to the requirements of SAE J514; (c) Transmitting torque to tube fittings without bearing on the apex of fitting wrenching points. Inclusion of dimensional data in this document is not intended to imply that all of the products described herein are stock production sizes. Consumers are requested to consult with manufacturers concerning lists of stock production sizes.
| SAE AMS4118L | Aluminum Alloy, Rolled or Cold Finished Bars, Rods, and Wire 4.0Cu - 0.70Mn - 0.60Mg - 0.50Si (2017; -T4, -T451) Solution Heat Treated |
| ASME B46.1 : 2009 | SURFACE TEXTURE (SURFACE ROUGHNESS, WAVINESS, AND LAY) |
| SAE J514_201201 | Hydraulic Tube Fittings |
| ASME B107.17 : 2015 | GAGES AND MANDRELS FOR WRENCH OPENINGS |
| SAE AS478N | Identification Marking Methods |
| SAE AS4984A | Coating Requirements for Aerospace Hand Tools |
| ASME B107.100 : 2010 | FLAT WRENCHES |
Access your standards online with a subscription
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.
Important note : All end users must be registered with an Account prior to user licenses being assigned.