PIP VEEVJ001 : 2015
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
GASKET GUIDELINES
Hardcopy , PDF
04-20-2023
English
01-01-2015
Important note : All end users must be registered with an Account prior to user licenses being assigned.
1. Introduction
2. References
3. Definitions
4. General
5. Standard Flange Gaskets
6. Custom Designed Gaskets
7. Gasket Materials
8. Gasket Dimensions
9. Gasket Marking
10. Gasket Purchase, Packaging,
Shipping, and Handling
11. Gasket Factors for Custom
Flange Design
12. Nubbins
13. Flange Surface Finishes
14. Bolted Joint Assembly
15. Gasket Reuse and Replacement
16. Refinishing of Flanges
17. Gaskets Between Flanges of
Dissimilar Materials
Appendix A - Common Leakage Causes
and Corrective Methods
Appendix B - Commentary
Specifies guidelines for specifying gaskets for circular flanges for pressurized equipment and piping.
| DocumentType |
Standard
|
| Pages |
37
|
| PublisherName |
Process Industry Practices
|
| Status |
Superseded
|
| SupersededBy |
| ASME PV CODE 8 DIV 2 : 2017 | BOILER AND PRESSURE VESSEL CODE - RULES FOR CONSTRUCTION OF PRESSURE VESSELS DIVISION 2- ALTERNATIVE RULES |
| ASME PV CODE 8 DIV 1 : 2017 | BOILER AND PRESSURE VESSEL CODE - RULES FOR CONSTRUCTION OF PRESSURE VESSELS DIVISION 1 |
| ASME PCC 1 : 2013 | GUIDELINES FOR PRESSURE BOUNDARY BOLTED FLANGE JOINT ASSEMBLY |
| ASME PCC 2 : 2015 | REPAIR OF PRESSURE EQUIPMENT AND PIPING |
| ASME B16.42 : 2016 | DUCTILE IRON PIPE FLANGES AND FLANGED FITTINGS - CLASSES 150 AND 300 |
| ASME B46.1 : 2009 | SURFACE TEXTURE (SURFACE ROUGHNESS, WAVINESS, AND LAY) |
| ASME B16.20 : 2012 | METALLIC GASKETS FOR PIPE FLANGES |
| PIP PNSM0105 : 2013 | PURCHASING REQUIREMENTS FOR GASKETS |
| ASME B16.1 : 2015 | Gray Iron Pipe Flanges and Flanged Fittings: Classes 25, 125, and 250 |
| PIP VESV1002 : 2012 | DESIGN AND FABRICATION SPECIFICATION FOR VESSELS ASME CODE SECTION 8, DIVISIONS 1 AND 2 |
| ASME B16.5 : 2017 | PIPE FLANGES AND FLANGED FITTINGS: NPS 1/2 THROUGH NPS 24 METRIC/INCH STANDARD |
| ASME B16.21 : 2016 | NONMETALLIC FLAT GASKETS FOR PIPE FLANGES |
| ASME B16.47 : 2017 | LARGE DIAMETER STEEL FLANGES: NPS 26 THROUGH NPS 60 METRIC/INCH STANDARD |
| PIP VESPMI01 : 2011 | POSITIVE MATERIAL IDENTIFICATION SPECIFICATION |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.