PD CEN/TR 14245:2014

Foreword
Introduction to this Guidelines Document
1 Scope
2 Normative references
3 Terms and definitions
4 Factory production control by the manufacturer
5 Tasks for the product certification body
6 Actions in the event of non-conformity
7 Procedure for third party certification of constancy
  of performance of the product
8 Certificate of constancy of performance of the product
  and conformity mark
9 Requirements for dispatching centres
Annex A (normative) - Evaluation of the representativeness
        and the accuracy of the 28 day strength test results
Annex B (informative) - Procedure for certification of
        constancy of performance of cement
Annex C (informative) - Comparison of terminology according
        to the CPD and the CPR
Bibliography

Defines the scheme for the assessment and verification of constancy of performance (AVCP) of cements to their corresponding product specification standards, including certification of constancy of performance by a product certification body.

This European Standard specifies the scheme for the assessment and verification of constancy of performance (AVCP) of cements to their corresponding product specification standards, including certification of constancy of performance by a product certification body. The standard provides technical rules for factory production control by the manufacturer, including autocontrol testing of samples, and for the tasks of the product certification body. It also provides rules for actions to be followed in the event of non-conformity, the procedure for the AVCP and requirements for dispatching centres. In this European Standard, the word “cement?? is used to refer both to common cements as defined in EN197‑1 and to other cements and binders for which the relevant product specification standard makes reference to this European Standard and which are submitted for certification. Such a cement is produced at a given factory and belongs to a particular type and a particular strength class, as defined and specified in the relevant product specification standard. The guidelines given in the Technical Report CEN/TR14245 [1] 1) should be used for the application of this European Standard. This European Standard should be linked with AnnexesZA of European Standards covering cements and binders, i.e. EN197‑1 , EN14216 , EN14647 , EN413‑1 , EN15743 , in particular for the assignments of tasks to the manufacturer and to the product certification body. NOTE The reason for having drafted this separate document is that the provisions it includes are applicable to different products covered by different European Standards. Guidance EN197‑2 deals with the evaluation of conformity of cements and binders that are submitted for certification. It deals in particular with cases where “further testing?? of the product is undertaken, as is the case for attestation system 1+under the Construction Products Regulation. The products for which EN197‑2 is applicable are: the common cement products and the low heat cements and the sulfate resisting cements, refer to EN197‑1 , the very low heat special cements, refer to EN14216 , the supersulfated cements, refer to EN15743 , the calcium aluminate cements, refer to EN14647 , and the masonry cements, refer to EN413‑1 .