NS EN 10208-2 : 2009

Foreword
Introduction
1 Scope
2 Normative references
3 Definitions
    3.1 General
    3.2 Types of pipes and welds
    3.3 Treatment condition
    3.4 Imperfections and defects
    3.5 Agreement
    3.6 Margin symbols
4 Classification and designation
5 Information to be supplied by the purchaser
    5.1 Mandatory information
    5.2 Other Information
    5.3 Example for ordering
6 Manufacturing
    6.1 General
    6.2 Steelmaking
    6.3 Pipe manufacturing
    6.4 Heat treatment condition
    6.5 Sizing
    6.6 Strip end welds
    6.7 Jointers
7 Requirements
    7.1 General
    7.2 Chemical composition
    7.3 Mechanical and technological properties
    7.4 Weldability
    7.5 Surface condition, imperfections and defects
    7.6 Dimensions, masses and tolerances
8 Inspection
    8.1 Types of inspection and inspection documents
    8.2 Specific inspection and testing
9 Marking of the pipes
    9.1 General marking
    9.2 Special marking
10 Coating for temporary protection
Annex A (informative) Correspondence with API steel grades
Annex B (normative) Manufacturing procedure qualification
Annex C (normative) Treatment of imperfection and defects
          disclosed by visual examination
Annex D (normative) Non-destructive testing
Annex E (informative) Bibliography

Defines technical delivery conditions for unalloyed and alloyed (not stainless) seamless and welded steel pipes, including quality and testing requirements not already specified in EN10208 Pt1. Applicable to pipes normally used for transmitting combustible fluids, and gives the maximum allowable operating pressure in the relevant design code.