NF EN 61041-5 : 1997

INTRODUCTION
SECTION 1: GENERAL REQUIREMENTS
1.1 Scope and object
1.2 Normative references
1.3 Conditions of measurement
1.4 Definitions
SECTION 2: VIDEO CHARACTERISTICS, LUMINANCE SIGNAL (NTSC/PAL)
2.1 Luminance signal-to-noise ratio
2.2 Horizontal resolution
2.3 Vertically correlated waveform distortion (waveform
      distortion of vertical luminance signal)
2.4 Diagonal resolution
2.5 Frequency characteristics of diagonal resolution
      (i) frequency response in two-dimensional frequency
      domain)
2.6 Frequency characteristics of diagonal resolution (ii)
      frequency response in Y/C separation system)
SECTION 3: VIDEO CHARACTERISTICS, CHROMINANCE SIGNAL
(NTSC/PAL)
3.1 Signal-to-noise ratio
3.2 Vertical picture displacement
3.3 Vertical picture distortion (waveform correlation
      distortion of chrominance signal)
3.4 Flicker
SECTION 4: MUTUAL CHARACTERISTICS, CHROMINANCE/LUMINANCE
SIGNALS (NTSC/PAL)
4.1 Luminance signal separation (general)
4.2 Luminance signal separation at colour change points
4.3 Chrominance signal separation
4.4 Crosstalk in electromagnetic conversion system
Figures
1 Composite video test signal
2 S luminance test signal
3 S chrominance test signal
4 Block diagram for composite video input
5 Block diagram for S video signal
6 Composite video test signal
7 Block diagram for composite video signal
8 Block diagram for S video signal
9 Composite video test signal
10 Waveform of overshoot
11 Waveform of pre-shoot
12 Waveform of smear
13 Waveform of rise and fall times
14 Waveform associated with reproduction of 1H/2H/3H pulses
15 Test signal on a TV monitor
16 Waveform for composite video signal
17 Waveform for S video input
18 Test signal on a TV monitor
19 Waveform identifying measurement points
20 Multiburst test signal
21 Measurement of burst levels
22 Composite video test signal
23 S luminance test signal
24 S chrominance test signal
25 Block diagram for composite video input
26 Block diagram for S video input
27 Composite colour window test signal
28 S luminance window test signal
29 S chrominance window test signal
30 Block diagram for composite video input
31 Block diagram for S video input
32 Waveform of S luminance signal
33 Waveform of S chrominance signal at line 0 (example
    measurement 1)
34 Waveform of S chrominance signal at line +1/2
    (example measurement 2)
35 Waveform of S chrominance signal at line +1 (example
    measurement 3)
36 Measurement of chrominance signal level
37 Block diagram for measurement
38 Example of colour vector measurement
39 Block diagram for measurement
40 Measurement of signal levels
41 Test signal
42 Measurement of signal levels
43 Multiburst test signal
44 Measurement of signal levels
45 Video frequency sweep test signal
46 Block diagram for measurement
47 Measurement of signal levels
Annex
ZA Normative references to international publications with
    their corresponding European publications

Defines the general requirements for methods of measurement for high-band video tape recorders, including those having Y/C video connector(s) (NTSC/PAL). Applies to machines using normal input/ output connectors for measuring the composite video signal, and to machines using Y/C video connector(s) known as S video connectors, for measuring the Y/C separated video signal. Applies when characteristics of the video and audio signals recorded and reproduced by means of high-band video tape recorders require checking and measuring.