NBN EN 12044 : 2005 + A1 2009

Foreword
1 Scope
2 Normative references
3 Terms and definitions
4 List of significant hazards
5 Safety requirements and/or measures
  5.1 General
  5.2 Common requirements for all cutting and
      punching machines
      5.2.1 Mechanical Equipment
      5.2.2 Electrical equipment
      5.2.3 Noise reduction
      5.2.4 High pressure fluid
      5.2.5 Control systems
      5.2.6 Emergency stop equipment
      5.2.7 Ergonomics
      5.2.8 Danger signals
  5.3 Requirements for specific machines
      5.3.1 Manual swing arm cutting press
      5.3.2 Powered swing arm cutting press
      5.3.3 Travelling head cutting press
      5.3.4 Beam cutting press
      5.3.5 Beam cutting press with receding head
      5.3.6 Beam cutting press with manual tray feeder
      5.3.7 Beam cutting press with articulated die carrier
             not attached to the beam
      5.3.8 Punching and perforating cutting press with
             manual or powered tray feeder
      5.3.9 C-Frame cutting press
      5.3.10 Automatic Press
6 Verification of the safety requirements and/or measures
7 Information for use
  7.1 Instructions for use - Instruction Handbook
  7.2 Information concerning airborne noise and vibration
      emissions
      7.2.1 Noise
      7.2.2 Vibrations (for hand guided machines only)
  7.3 Marking
Annex A (normative) - Interlocking devices associated with
                      guards
Annex B (normative) - Hold-to-run control devices
Annex C (normative) - Mechanical trip device with one position
                      sensor
Annex D (normative) - Well tried components and principles:
                      category 1 of EN 954-1:1996
Annex E (normative) - Verification of one hand control up to a
                      maximum stroke of 8 mm
Annex F (normative) - Noise Test Code
Annex ZA (informative) - Relationship between this European
                         Standard and the Essential Requirements
                         of EU Directive 98/37/EC
Bibliography

Defines safety requirements for design and operation of the machines.