ICC IFGC CODE AND COMMENTARY : 2015
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
IFGC® Code and Commentary
Hardcopy , PDF
English
01-01-2015
07-21-2020
CHAPTER 1 - SCOPE AND ADMINISTRATION
PART 1 - SCOPE AND APPLICATION
PART 2 - ADMINISTRATION AND ENFORCEMENT
CHAPTER 2 - DEFINITIONS
CHAPTER 3 - GENERAL REGULATIONS
CHAPTER 4 - GAS PIPING INSTALLATIONS
CHAPTER 5 - CHIMNEYS AND VENTS
CHAPTER 6 - SPECIFIC APPLIANCES
CHAPTER 7 - GASEOUS HYDROGEN
SYSTEMS
CHAPTER 8 - REFERENCED STANDARDS
APPENDIX A - SIZING AND CAPACITIES OF
GAS PIPING (IFGS)
APPENDIX B - SIZING OF VENTING SYSTEMS
SERVING APPLIANCES EQUIPPED
WITH DRAFT HOODS, CATEGORY
I APPLIANCES AND APPLIANCES
LISTED FOR USE WITH TYPE
B VENTS (IFGS)
APPENDIX C - EXIT TERMINALS OF MECHANICAL
DRAFT AND DIRECT-VENT VENTING
SYSTEMS (IFGS)
APPENDIX D - RECOMMENDED PROCEDURE
FOR SAFETY INSPECTION OF AN
EXISTING APPLIANCE INSTALLATION (IFGS)
INDEX
This code shall apply to the installation of fuel-gas piping systems, fuel gas appliances, gaseous hydrogen systems and related accessories.
| DocumentType |
Standard
|
| ISBN |
978-1-6083-292-6
|
| Pages |
427
|
| ProductNote |
HIS STANDARD ALSO REFERS TO ANSI A13.1-2007,BPVC—2010/2011 addenda,CSD-1—2011,CGA S 1.2-2005,CSA 8—93,CSA FC1—2012,
|
| PublisherName |
International Code Council (ICC)
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
| UL 103:11ED 2010-10-15 | Factory-Built Chimneys for Residential Type and Building Heating Appliances |
| ICC IECC INTERNATIONAL ENERGY CONSERVATION CODE : 2015 | INTERNATIONAL ENERGY CONSERVATION CODE |
| ICC IRC INTERNATIONAL RESIDENTIAL CODE : 2015 | INTERNATIONAL RESIDENTIAL CODE FOR ONE- AND TWO-FAMILY DWELLINGS |
| NFPA 58 : 2017 | LIQUEFIED PETROLEUM GAS CODE |
| NFPA 30A : 2018 | MOTOR FUEL DISPENSING FACILITIES AND REPAIR GARAGES |
| NFPA 853 : 2010 | INSTALLATION OF STATIONARY FUEL CELL POWER SYSTEMS |
| CSA/ANSI Z21.40.1 : 1996 | GAS-FIRED, HEAT ACTIVATED AIR CONDITIONING AND HEAT PUMP APPLIANCES |
| CSA 6.22 : 2011 | LINE PRESSURE REGULATORS |
| UL 2200:2ED 2012-06-01 | Standard for Stationary Engine Generator Assemblies |
| UL 795:8ED 2016-12-02 | Commercial-Industrial Gas Heating Equipment |
| NFPA 88A : 2015 | PARKING STRUCTURES |
| ASTM A 254 : 1997 | Standard Specification for Copper-Brazed Steel Tubing |
| UL 651:8ED 2011-10-25 | Schedule 40, 80, Type EB and A Rigid PVC Conduit and Fittings |
| UL 1618:2ED 2015-10-23 | Wall Protectors, Floor Protectors, and Hearth Extensions |
| CSA/ANSI Z21.61 : 1983 | GAS-FIRED TOILETS |
| UL 959:9ED 2010-12-17 | Medium Heat Appliance Factory-Built Chimneys |
| ASTM D 2513 : 2017-01 | SPECIFICATION FOR POLYETHYLENE (PE) GAS PRESSURE PIPE, TUBING, AND FITTINGS |
| ASTM E 136 : 2016-02 | TEST METHOD FOR BEHAVIOUR OF MATERIALS IN A VERTICAL TUBE FURNACE AT 750 DEGREES C |
| ASTM B 88 : 2016 : REDLINE | Standard Specification for Seamless Copper Water Tube |
| UL 441:11ED 2016-04-08 | Gas Vents |
| ICC IBC INTERNATIONAL BUILDING CODE : 2015 | INTERNATIONAL BUILDING CODE |
| NFPA 85 : 2015 | BOILER AND COMBUSTION SYSTEMS HAZARDS CODE |
| NFPA 70 : 2017 | NATIONAL ELECTRICAL CODE |
| NFPA 51 : 2018 | DESIGN AND INSTALLATION OF OXYGEN-FUEL GAS SYSTEMS FOR WELDING, CUTTING, AND ALLIED PROCESSES |
| CGA S 1.2 : 2009 | PRESSURE RELIEF DEVICE STANDARDS - PART 2: PORTABLE CONTAINERS FOR COMPRESSED GASES |
| NFPA 409 : 2016 | AIRCRAFT HANGARS |
| CFR 49(PTS178-199) : OCT 2017 | TRANSPORTATION |
| ICC IMC INTERNATIONAL MECHANICAL CODE : 2015 | INTERNATIONAL MECHANICAL CODE |
| ASTM B 241/B241M : 2016 : REDLINE | Standard Specification for Aluminum and Aluminum-Alloy Seamless Pipe and Seamless Extruded Tube |
| NFPA 82 : 2014 | INCINERATORS AND WASTE AND LINEN HANDLING SYSTEMS AND EQUIPMENT |
| NFPA 37 : 2018 | INSTALLATION AND USE OF STATIONARY COMBUSTION ENGINES AND GAS TURBINES |
| ICC IPC INTERNATIONAL PLUMBING CODE : 2015 | INTERNATIONAL PLUMBING CODE (INCLUDES IPSDC) |
| NFPA 211 : 2016 | CHIMNEYS, FIREPLACES, VENTS, AND SOLID FUEL-BURNING APPLIANCES |
| CSA/ANSI Z21.5.1 : 2016 | GAS CLOTHES DRYERS, VOLUME 1, TYPE 1 CLOTHES DRYERS |
| CGA S 1.3 : 2008 | PRESSURE RELIEF DEVICE STANDARDS - PART 3: STATIONARY STORAGE CONTAINERS FOR COMPRESSED GASES |
| ICC IFC INTERNATIONAL FIRE CODE : 2015 | INTERNATIONAL FIRE CODE |
| CGA S 1.1 : 2011 | PRESSURE RELIEF DEVICE STANDARDS - PART 1: CYLINDERS FOR COMPRESSED GASES |
| MSS SP 58 : 2009 | PIPE HANGERS AND SUPPORTS - MATERIALS, DESIGN, MANUFACTURE, SELECTION, APPLICATION, AND INSTALLATION |
| CFR 49(PTS100-185) : 0 | TRANSPORTATION |
Access your standards online with a subscription
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.
Important note : All end users must be registered with an Account prior to user licenses being assigned.Logging out.