I.S. EN ISO 294-2:1998
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
PLASTICS - INJECTION MOULDING OF TEST SPECIMENS OF THERMOPLASTIC MATERIALS - PART 2: SMALL TENSILE BARS
Hardcopy , PDF
English
01-01-1998
01-25-2019
For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.
Only cited Standards give presumption of conformance to New Approach Directives/Regulations.
Foreword
1 Scope
2 Normative references
3 Definitions
4 Apparatus
5 Procedure
6 Report on test-specimen preparation
Annex ZA (normative) Normative references to international
publications with their relevant
European publications
Defines a four-cavity mould, the type C ISO mould, for the injection moulding of small tensile bars measuring greater than or equal to 60 mm x 10 mm x 3 mm.
| DocumentType |
Standard
|
| Pages |
22
|
| PublisherName |
National Standards Authority of Ireland
|
| Status |
Superseded
|
| SupersededBy |
| Standards | Relationship |
| ONORM EN ISO 294-2 : 1998 | Identical |
| NBN EN ISO 294-2 : 1998 AMD 1 2005 | Identical |
| NS EN ISO 294-2 : 1998 AMD 1 2005 | Identical |
| BS EN ISO 294-2:1998 | Identical |
| ISO 294-2:1996 | Identical |
| NEN EN ISO 294-2 : 1998 AMD 1 2005 | Identical |
| DIN EN ISO 294-2:2006-05 | Identical |
| NF EN ISO 294-2 : 1998 AMD 1 2005 | Identical |
| EN ISO 294-2:1998 | Equivalent |
| UNE-EN ISO 294-2:1999 | Identical |
| EN ISO 8256:2004 | Plastics - Determination of tensile-impact strength (ISO 8256:2004) |
| ISO 11403-3:2014 | Plastics — Acquisition and presentation of comparable multipoint data — Part 3: Environmental influences on properties |
| ISO 8256:2004 | Plastics — Determination of tensile-impact strength |
| ISO 294-1:2017 | Plastics — Injection moulding of test specimens of thermoplastic materials — Part 1: General principles, and moulding of multipurpose and bar test specimens |
| EN ISO 294-1:2017 | Plastics - Injection moulding of test specimens of thermoplastic materials - Part 1: General principles, and moulding of multipurpose and bar test specimens (ISO 294-1:2017) |
Access your standards online with a subscription
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.
Important note : All end users must be registered with an Account prior to user licenses being assigned.