I.S. EN ISO 23936-1:2009

Foreword
Introduction
1 Scope
2 Normative references
3 Terms, definitions and abbreviated terms
  3.1 Terms and definitions
  3.2 Abbreviated terms
4 Functional requirements
  4.1 General
  4.2 Pipelines, piping and liners
  4.3 Seals, washers and gaskets
  4.4 Encapsulations, electrical insulations, injection
      lines
5 Requirements for technical information
6 Requirements for manufacturers
  6.1 General requirements
  6.2 Raw material manufacturer
  6.3 Component manufacturer
  6.4 Validity of qualification
7 Qualification of thermoplastic materials
  7.1 General
  7.2 Requirements for chemical resistance tests
Annex A (informative) - Typical chemical properties of
        commonly used thermoplastic materials in media
        encountered in oil and gas production
Annex B (normative) - Test media, conditions, equipment,
        procedures and test report requirements
Bibliography

Describes general principles and gives requirements and recommendations for the selection and qualification, and gives guidance for the quality assurance, of non-metallic materials for service in equipment used in oil and gas production environments, where the failure of such equipment could pose a risk to the health and safety of the public and personnel or to the environment.