I.S. EN ISO 16396-1:2015
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
PLASTICS - POLYAMIDE (PA) MOULDING AND EXTRUSION MATERIALS - PART 1: DESIGNATION SYSTEM, MARKING OF PRODUCTS AND BASIS FOR SPECIFICATIONS (ISO 16396-1:2015)
Hardcopy , PDF
05-29-2023
English
01-01-2015
For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.
Only cited Standards give presumption of conformance to New Approach Directives/Regulations.
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Foreword
Introduction
1 Scope
2 Normative references
3 Designation system
4 Examples of designations
Annex A (normative) - Definition and designation
of polyamides
Bibliography
Defines a system of designation for polyamide (PA) moulding and extrusion materials, which can be used as the basis for specifications.
| DevelopmentNote |
Supersedes I.S. EN ISO 1874-1. (03/2015)
|
| DocumentType |
Standard
|
| Pages |
32
|
| PublisherName |
National Standards Authority of Ireland
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
| Standards | Relationship |
| ISO 16396-1:2015 | Identical |
| EN ISO 16396-1:2015 | Identical |
| ISO 11469:2016 | Plastics — Generic identification and marking of plastics products |
| ASTM D 6779 : 2017 : REDLINE | Standard Classification System for and Basis of Specification for Polyamide Molding and Extrusion Materials (PA) |
| ISO 527-2:2012 | Plastics — Determination of tensile properties — Part 2: Test conditions for moulding and extrusion plastics |
| ISO 1874-2:2012 | Plastics Polyamide (PA) moulding and extrusion materials Part 2: Preparation of test specimens and determination of properties |
| ISO 472:2013 | Plastics — Vocabulary |
| ISO 307:2007 | Plastics Polyamides Determination of viscosity number |
| ISO 1043-2:2011 | Plastics — Symbols and abbreviated terms — Part 2: Fillers and reinforcing materials |
| ISO 1043-1:2011 | Plastics — Symbols and abbreviated terms — Part 1: Basic polymers and their special characteristics |
| ISO 1043-4:1998 | Plastics Symbols and abbreviated terms Part 4: Flame retardants |
| ISO 3451-4:1998 | Plastics — Determination of ash — Part 4: Polyamides |
| (INACTIVE RECORD)ASTM D 5336 : 2015-04 | CLASSIFICATION SYSTEM AND BASIS FOR SPECIFICATION FOR POLYPHTHALAMIDE (PPA) INJECTION MOLDING MATERIALS |
| ISO 527-1:2012 | Plastics Determination of tensile properties Part 1: General principles |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.