I.S. EN ISO 15403:2005
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
NATURAL GAS - DESIGNATION OF THE QUALITY OF NATURAL GAS FOR USE AS A COMPRESSED FUEL FOR VEHICLES
Hardcopy , PDF
04-02-2008
English
01-01-2005
For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.
Only cited Standards give presumption of conformance to New Approach Directives/Regulations.
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Symbols and abbreviations
5 Gas composition requirements
6 Gas properties
7 Driveability
8 Test methods
9 Sampling
Annex A (informative) Propane and butane content
Annex B (informative) Wobbe index range
Annex C (informative) Engine knock
Annex D (informative) Methane number and octane number
Annex E (informative) Water content of natural gas
Bibliography
Covers manufacturers, vehicle operators, fuelling station operators and others involved in the compressed-natural-gas vehicle industry with information on the fuel quality for natural gas vehicles (NGVs) required to develop and operate compressed-natural-gas vehicle equipment successfully.
| DocumentType |
Standard
|
| Pages |
34
|
| PublisherName |
National Standards Authority of Ireland
|
| Status |
Superseded
|
| SupersededBy |
| Standards | Relationship |
| EN ISO 15403:2005 | Identical |
| ISO 15403:2000 | Identical |
| ISO 6570-1:1983 | Natural gas Determination of potential hydrocarbon liquid content Part 1: Principles and general requirements |
| ISO 10715:1997 | Natural gas — Sampling guidelines |
| ISO 5164:2014 | Petroleum products — Determination of knock characteristics of motor fuels — Research method |
| ISO 6976:2016 | Natural gas — Calculation of calorific values, density, relative density and Wobbe indices from composition |
| ISO 6327:1981 | Gas analysis — Determination of the water dew point of natural gas — Cooled surface condensation hygrometers |
| ISO 12213-3:2006 | Natural gas Calculation of compression factor Part 3: Calculation using physical properties |
| ISO 7941:1988 | Commercial propane and butane Analysis by gas chromatography |
| ISO 10101-1:1993 | Natural gas — Determination of water by the Karl Fischer method — Part 1: Introduction |
| ISO 13734:2013 | Natural gas — Organic components used as odorants — Requirements and test methods |
| ISO 13686:2013 | Natural gas Quality designation |
| EN 589:2008+A1:2012 | Automotive fuels - LPG - Requirements and test methods |
| ISO 5163:2014 | Petroleum products — Determination of knock characteristics of motor and aviation fuels — Motor method |
| EN 437:2003+A1:2009 | Test gases - Test pressures - Appliance categories |
| ISO 14532:2014 | Natural gas — Vocabulary |
| ISO 6570-2:1984 | Natural gas Determination of potential hydrocarbon liquid content Part 2: Weighing method |
| NFPA 52 : 2016 | VEHICULAR NATURAL GAS FUEL SYSTEMS CODE |
| ISO 10101-2:1993 | Natural gas — Determination of water by the Karl Fischer method — Part 2: Titration procedure |
| ISO 13443:1996 | Natural gas Standard reference conditions |
| ISO 10101-3:1993 | Natural gas — Determination of water by the Karl Fischer method — Part 3: Coulometric procedure |
| ISO 6326-1:2007 | Natural gas Determination of sulfur compounds Part 1: General introduction |
| ISO 11541:1997 | Natural gas Determination of water content at high pressure |
| AGA NGV 2 : 1992 | BASIC REQUIREMENTS FOR COMPRESSED NATURAL GAS VEHICLE (NGV) FUEL CONTAINERS |
| ISO 12213-1:2006 | Natural gas Calculation of compression factor Part 1: Introduction and guidelines |
| ISO 6326-5:1989 | Natural gas Determination of sulfur compounds Part 5: Lingener combustion method |
| ISO 6326-3:1989 | Natural gas Determination of sulfur compounds Part 3: Determination of hydrogen sulfide, mercaptan sulfur and carbonyl sulfide sulfur by potentiometry |
| ISO 6326-4:1994 | Natural gas — Determination of sulfur compounds — Part 4: Gas chromatographic method using a flame photometric detector for the determination of hydrogen sulfide, carbonyl sulfide and sulfur-containing odorants |
| ISO 12213-2:2006 | Natural gas Calculation of compression factor Part 2: Calculation using molar-composition analysis |
| SAE J 1616 : 2017 | RECOMMENDED PRACTICE FOR COMPRESSED NATURAL GAS VEHICLE FUEL |
| ISO 6326-2:1981 | Gas analysis Determination of sulphur compounds in natural gas Part 2: Gas chromatographic method using an electrochemical detector for the determination of odoriferous sulphur compounds |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.