I.S. EN 62364:2013
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
HYDRAULIC MACHINES - GUIDE FOR DEALING WITH HYDRO-ABRASIVE EROSION IN KAPLAN, FRANCIS, AND PELTON TURBINES (IEC 62364:2013 (EQV))
Hardcopy , PDF
02-18-2022
English
01-01-2013
For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.
Only cited Standards give presumption of conformance to New Approach Directives/Regulations.
Important note : All end users must be registered with an Account prior to user licenses being assigned.
FOREWORD
INTRODUCTION
1 Scope
2 Terms, definitions and symbols
3 Abrasion rate
4 Design
5 Abrasion resistant materials
6 Guidelines on insertions into specifications
Annex A (informative) - PL calculation example
Annex B (informative) - Measuring and recording
abrasion damages
Annex C (informative) - Water sampling procedure
Annex D (informative) - Procedures for analysis of
particle concentration, size, hardness and
shape
Annex E (informative) - Tests of abrasion resistant
materials
Annex F (informative) - Typical criteria to determine
overhaul time due to abrasion erosion
Annex G (informative) - Example to calculate the
amount of erosion in the full model
Annex H (informative) - Examples to calculate the
TBO in the reference model
Bibliography
Specifies to present data on particle abrasion rates on several combinations of water quality, operating conditions, component materials, and component properties collected from a variety of hydro sites.
| DevelopmentNote |
For CENELEC adoptions of IEC publications, please check www.iec.ch to be sure that you have any corrigenda that may apply. (01/2017)
|
| DocumentType |
Standard
|
| Pages |
77
|
| PublisherName |
National Standards Authority of Ireland
|
| Status |
Superseded
|
| SupersededBy |
| Standards | Relationship |
| EN 62364:2013 | Identical |
| ISO 4365:2005 | Liquid flow in open channels Sediment in streams and canals Determination of concentration, particle size distribution and relative density |
| IEC TR 61364:1999 | Nomenclature for hydroelectric powerplant machinery |
| IEC 60193:1999 | Hydraulic turbines, storage pumps and pump-turbines - Model acceptance tests |
| ASTM G 76 : 2013-07 | TEST METHOD FOR CONDUCTING EROSION TESTS BY SOLID PARTICLE IMPINGEMENT USING GAS JETS |
| IEC 60609-2:1997 | Cavitation pitting evaluation in hydraulic turbines, storage pumps and pump-turbines - Part 2: Evaluation in Pelton turbines |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.