I.S. EN 61642:1999

FOREWORD
1 General
  1.1 Scope and object
  1.2 Normative references
  1.3 Definitions
  1.4 General considerations
      1.4.1 AC harmonics
      1.4.2 Reactive power
2 Resonance problems and solutions
  2.1 Introduction
  2.2 Supply impedance view, load-busbar impedance view
  2.3 Example of series resonance
  2.4 Example of parallel resonance
  2.5 Solutions to avoid resonances
      2.5.1 Capacitor-reactor connection: series resonance
      2.5.2 Capacitor-reactor connection: parallel resonance
3 Shunt capacitors and filters for networks having a voltage
  up to and including 1 000 V
  3.1 Introduction
  3.2 Shunt capacitors
  3.3 Detuned filter
  3.4 Tuned filter
  3.5 Components selection
      3.5.1 Capacitors
      3.5.2 Reactors
      3.5.3 Contactors and/or circuit-breakers
      3.5.4 Short-circuit protection (fuses)
  3.6 Disturbance of ripple control installations by shunt
      capacitors and filters
      3.6.1 Shunt capacitors
      3.6.2 Detuned filter
      3.6.3 Tuned filter
4 Shunt capacitors and filters for networks having a voltage
  above 1 000 V
  4.1 Introduction
  4.2 Specific requirements
  4.3 Choice of power factor correction installation
  4.4 Type of filters
  4.5 Filter components selection
      4.5.1 Circuit-breaker
      4.5.2 Capacitors
      4.5.3 Reactors
      4.5.4 Resistors
      4.5.5 Relay protection
  4.6 Disturbance of ripple control installations by shunt
      capacitors and filters
Annex A - Bibliography
Annex ZA (normative) Normative references to international
         publications with their corresponding European
         publications

Covers guidance for the use of passive a.c. harmonic filters and shunt capacitors for the limitation of harmonics and power factor correction intended to be used in industrial applications, at low and high voltages.