I.S. EN 61180-2:1995
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
HIGH VOLTAGE TEST TECHNIQUE FOR LOW-VOLTAGE EQUIPMENT - PART 2: TEST EQUIPMENT
Hardcopy , PDF
11-15-2016
English
01-01-1995
For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.
Only cited Standards give presumption of conformance to New Approach Directives/Regulations.
Important note : All end users must be registered with an Account prior to user licenses being assigned.
FOREWORD
1 Scope
2 Normative references
3 Definitions
4 General conditions for verification of test equipment
4.1 Atmospheric conditions
4.2 Connections and arrangement
4.3 Influence of the load
4.4 Comparison procedure
4.5 Frequency of verifications
5 Verification of characteristics of direct voltage
generators
5.1 Ripple factor
5.2 Permitted measuring error
5.3 Voltage regulation
6 Verification of characteristics of alternating
voltage generators
6.1 Voltage wave-form
6.2 Permitted measuring error
6.3 Minimum test voltage
7 Verification of characteristics of impulse voltage
generators
7.1 Voltage wave-form
7.2 Permitted measuring error
7.3 Conventional output impedance
8 Verification of characteristics of impulse current
generators
8.1 Current wave-form
8.2 Permitted measuring error
9 Verification of characteristics of hybrid impulse
voltage generators
9.1 Wave-form and permitted measuring error
9.2 Virtual impedance
10 Requirements for reference measuring systems
10.1 Direct voltage
10.2 Alternating voltage
10.3 Lightning impulse voltage
10.4 Impulse current
10.5 Comparative measurement
Annex A - Bibliography
ANNEX ZA (normative) OTHER INTERNATIONAL PUBLICATIONS
QUOTED IN THIS STANDARD WITH THE REFERENCES OF THE
RELEVANT EUROPEAN PUBLICATIONS
Applies to the test equipment used for dielectric tests on low-voltage equipment. It covers tests with direct, alternating or impulse voltage, impulse current, and tests with a combination of impulse voltage and impulse current.
| DevelopmentNote |
For CENELEC adoptions of IEC publications, please check www.iec.ch to be sure that you have any corrigenda that may apply. (01/2017)
|
| DocumentType |
Standard
|
| Pages |
26
|
| PublisherName |
National Standards Authority of Ireland
|
| Status |
Superseded
|
| SupersededBy |
| Standards | Relationship |
| IEC 61180-2:1994 | Identical |
| SN EN 61180-2 : 1994 | Identical |
| BS EN 61180-2:1995 | Identical |
| DIN EN 61180-2 : 1995 | Identical |
| NBN EN 61180-2 : 2000 | Identical |
| EN 61180-2:1994 | Identical |
| NF EN 61180-2 : 1995 | Identical |
| UNE-EN 61180-2:1996 | Identical |
| IEC 60060-2:2010 | High-voltage test techniques - Part 2: Measuring systems |
| IEC 60068-1:2013 | Environmental testing - Part 1: General and guidance |
| EN 60068-1:2014 | Environmental testing - Part 1: General and guidance |
| HD 479 : 200S1 | OSCILLOSCOPES AND PEAK VOLTMETERS FOR IMPULSE TESTS |
| IEC 60790:1984 | Oscilloscopes and peak voltmeters for impulse tests |
| EN 61083-1:2001 | Instruments and software used for measurement in high-voltage impulse tests - Part 1: Requirements for instruments |
| IEC 61180-1:1992 | High-voltage test techniques for low voltage equipment - Part 1: Definitions, test and procedure requirements |
| IEC 61083-1:2001 | Instruments and software used for measurement in high-voltage impulse tests - Part 1: Requirements for instruments |
| EN 61180-1:1994 | High-voltage test techniques for low-voltage equipment - Part 1: Definitions, test and procedure requirements |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.