• Shopping Cart
    There are no items in your cart

I.S. EN 50083-5:2001

Superseded

Superseded

A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

View Superseded by

CABLE NETWORKS FOR TELEVISION SIGNALS, SOUND SIGNALS AND INTERACTIVE SERVICES - PART 5: HEADEND EQUIPMENT

Available format(s)

Hardcopy , PDF

Superseded date

01-12-2010

Superseded by

I.S. EN 60728-5:2016

Language(s)

English

Published date

01-01-2001

Preview

For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.

Only cited Standards give presumption of conformance to New Approach Directives/Regulations.

US$98.07
Excluding Tax where applicable

1 Scope
   1.1 General
   1.2 Specific scope of this part 5
2 Normative references
3 Terms, definitions, symbols and abbreviations
   3.1 Terms and definitions
   3.2 Symbols
   3.3 Abbreviation
4 Methods of measurement
   4.1 Single-channel intermodulation
   4.2 Three-carrier intermodulation measurement
   4.3 Two carrier intermodulation measurement for
        second and third order products
   4.4 Carrier-to-spurious signal ratio at the output
   4.5 Television carrier-to-noise ratio
   4.6 Differential gain and phase for PAL/SECAM signals
   4.7 Group delay variation
   4.8 2T-pulse response, K-factor
   4.9 Chrominance-luminance delay inequalities
        (20T-pulse method)
   4.10 Luminance non-linearity
   4.11 Intermodulation distortion (FM stereo radio)
   4.12 Decoding margin (Teletext)
   4.13 Hum modulation of carrier
5 Performance requirements and recommendations
   5.1 Safety
   5.2 Electromagnetic compatability
   5.3 Environmental
   5.4 Marking
   5.5 Mean time operation between failure (MTBF)
6 Signal requirements
   6.1 Indoor units
   6.2 Outdoor units
7 Data publication requirements
   7.1 General
   7.2 Indoor units - TV (AM and FM)
   7.3 Indoor units - FM radio
   7.4 Outdoor units
Annex A (normative) Definition of the specified test
        frequency range for return loss and noise figure
Annex B (normative) Audio connector
Annex C (informative) Selectivity diagram for adjacent
        channel transmission
Annex D (normative) Special national conditions
Annex E (informative) Measurement errors which occur due
        to mismatched equipment

Specifies the characteristics of equipment used in the headends of terrestrial broadcast and satellite receiving systems.

DocumentType
Standard
Pages
56
PublisherName
National Standards Authority of Ireland
Status
Superseded
SupersededBy

Standards Relationship
UNE-EN 50083-5:2002 Identical
NBN EN 50083-5 : 2002 Identical
DIN EN 50083-5 : 2001 Identical
SN EN 50083-5 : 2001 Identical
NEN EN 50083-5 : 2001 Identical
EN 50083-5:2001 Identical
NF EN 50083-5 : 2002 Identical
BS EN 50083-5:2002 Identical

ETS 300 457 : 20001 SATELLITE EARTH STATIONS AND SYSTEMS (SES) - TEST METHODS FOR TELEVISION RECEIVE ONLY (TVRO) OPERATING IN THE 11/12 GHZ FREQUENCY BANDS
HD 134.2 : 200S2 RADIO-FREQUENCY CONNECTORS - COAXIAL UNMATCHED CONNECTOR
EN 60417-1:2002 GRAPHICAL SYMBOLS FOR USE ON EQUIPMENT - PART 1: OVERVIEW AND APPLICATION
EN 50083-3:2002 Cable networks for television signals, sound signals and interactive services - Part 3: Active wideband equipment for coaxial cable networks
EN 50083-2:2012/A1:2015 CABLE NETWORKS FOR TELEVISION SIGNALS, SOUND SIGNALS AND INTERACTIVE SERVICES - PART 2: ELECTROMAGNETIC COMPATIBILITY FOR EQUIPMENT
EN 60417-2:1999 Graphical symbols for use on equipment - Part 2: Symbol originals
ETS 300 249 : 20001 SATELLITE EARTH STATIONS (SES); TELEVISION RECEIVE-ONLY (TVRO) EQUIPMENT USED IN THE BROADCASTING SATELLITE SERVICE (BSS)
ETS 300 158 : 20001 SATELLITE EARTH STATIONS (SES); TELEVISION RECEIVE-ONLY (TVRO-FSS) SATELLITE EARTH STATIONS OPERATING IN THE 11/12 GHz FSS BANDS
EN 60130-9:2011 Connectors for frequencies below 3 MHz - Part 9: Circular connectors for radio and associated sound equipment
IEC 60169-8:1978 Radio-frequency connectors. Part 8: R.F. coaxial connectors with inner diameter of outer conductor 6.5 mm (0.256 in) with bayonet lock - Characteristic impedance 50 ohms (Type BNC)
EN 50083-1:1993/A2:1997 CABLE NETWORKS FOR TELEVISION SIGNALS, SOUND SIGNALS AND INTERACTIVE SERVICES - PART 1: SAFETY REQUIREMENTS
EN 60529:1991/AC:2016-12 DEGREES OF PROTECTION PROVIDED BY ENCLOSURES (IP CODE) (IEC 60529 EDITION 2.2 CORRIGENDUM 2:2015)
HD 571 : 200S1 GENERAL PRINCIPLES FOR THE CREATION OF GRAPHICAL SYMBOLS FOR USE ON EQUIPMENT
EN 60244-5:1994 Methods of measurement for radio transmitters - Part 5: Performance characteristics for television transmitters
EN 300 473 : 1.1.2 DIGITAL VIDEO BROADCASTING (DVB); SATELLITE MASTER ANTENNA TELEVISION (SMATV) DISTRIBUTION SYSTEMS
EN 300 163 : 1.2.1 TELEVISION SYSTEMS; NICAM 728: TRANSMISSION OF TWO-CHANNEL DIGITAL SOUND WITH TERRESTRIAL TELEVISION SYSTEMS B,G,H,I,K1 AND L

Access your standards online with a subscription

Features

  • Simple online access to standards, technical information and regulations.

  • Critical updates of standards and customisable alerts and notifications.

  • Multi-user online standards collection: secure, flexible and cost effective.