I.S. EN 13814:2005

Foreword
1 Scope
2 Normative references
3 Terms and definitions
4 Symbols
5 Common requirements for design analysis and examination
  5.1 Design documents
  5.2 Selection of materials
  5.3 Design loads
  5.4 Structural analysis - Principles
  5.5 Verification of stability
  5.6 Verification of strength
  5.7 Structural design and workmanship
6 Requirements for design and manufacture of rides and
  structures
  6.1 Risk reduction by prevailing design and safety
       measures
  6.2 Supplementary safety requirements for various types of
       amusement device
  6.3 Mechanical systems
  6.4 Manufacture and supply
  6.5 Initial approval, examination and acceptance - Recommended
       procedures
  6.6 Provisions before supply and use
7 Operation and use of rides and structures
  7.1 Introduction
  7.2 Standard documentation
  7.3 Requirements for Personnel
  7.4 Duties of the controller
  7.5 Duties of the amusement device operator
  7.6 Duties of the attendant
  7.7 Independent examinations
  7.8 Fire
Annex A (informative) Fatigue analysis
  A.1 General
  A.2 Symbols and definitions
  A.3 Requirements for fatigue assessment
  A.4 Fatigue strength of steel structures
  A.5 Damage assessment for combined stresses
  A.6 Formulae for life time prediction
Annex B (normative) Detailed analysis rules
  B.1 Swings
  B.2 Ferris wheels
  B.3 Chair-O-Planes and suspension roundabouts
  B.4 Roundabout with floor (suspended floor and turntable
       roundabouts)
  B.5 Motor-driven vehicle attractions
  B.6 Steep wall tracks
  B.7 Globes
  B.8 Installations for artistic aerial displays
  B.9 Rotors
  B.10 Toboggans
  B.11 Rolling barrels
  B.12 Travelling platforms
  B.13 Turntables
Annex C (normative) Examination forms
  C.1 Thorough examination form
  C.2 Initial examination form
Annex D (normative) Electrical equipment and Control systems
  D.1 Electrical equipment
  D.2 Control systems
Annex E (informative) Guidance on design of passenger containment
Annex F (informative) Log Book for an amusement device
Annex G (informative) Acceleration Effects on Passengers
  G.1 Medical tolerance - General
  G.2 Rides
Annex H (informative) Provisions prior to use
  H.1 General
  H.2 Operation Authorisation or Permit
  H.3 Competence
  H.4 Operation authorisation or permit for used and
       imported devices
  H.5 Prolongation and Transfer of the Operation
  H.6 Reports for the prolongation of an operation
       authorisation or permit
  H.7 Testing
  H.8 Inspection bodies
  H.9 Installation Examination
  H.10 Examples of examination intervals used by member
       states' regulations
Annex I (informative) List of hazards
Bibliography

Defines the minimum requirements necessary to ensure the safe design, calculation, manufacture, installation, maintenance, operation, examination and testing of the following: mobile, temporary or permanently installed machinery and structures e.g. roundabouts, swings, boats, ferris wheels, roller coasters, chutes, grandstands, membrane or textile structures, booths, stages, side shows, and structures for artistic aerial displays.