EN 60317-52:2014

FOREWORD
INTRODUCTION
1 Scope
2 Normative references
3 Terms, definitions, general notes
   and appearance
4 Dimensions
5 Electrical resistance
6 Elongation
7 Springiness
8 Flexibility and adherence
9 Heat shock
10 Cut-through
11 Resistance to abrasion
12 Resistance to solvents
13 Breakdown voltage
14 Continuity of insulation
15 Temperature index
16 Resistance to refrigerants
17 Solderability
18 Heat or solvent bonding
19 Dielectric dissipation factor
20 Resistance to hydrolysis and
   to transformer oil
21 Loss of mass
23 Pin hole test
30 Packaging
Annex A (informative) - Nominal conductor
        diameters for intermediate
        sizes (R40)
Annex B (informative) - Example of tape
        wrapped wire
Annex C (informative) - Resistance
Bibliography
Annex ZA (normative) - Normative references to
         International publications with their
         corresponding European publications

IEC 60317-52:2014 specifies requirements for tape wrapped round copper winding wire of temperature index 220. The insulation consists of one or more wrappings of aromatic polyamide (aramid) tape of various thicknesses. The range of nominal conductor diameters covered by this standard is: - 1,600 mm up to and including 5,000 mm; - the nominal conductor diameters are given in Table 1. This second edition cancels and replaces the first edition published in 1999. This edition constitutes a technical revision. This edition includes the following significant technical changes with respect to the previous edition: - new 3.2.2 containing general notes on winding wire, formerly a part of the scope; - new 3.3, containing requirements for appearance; - modification to Clause 15 to delete the note on revisions to IEC 60172; - new Clause 23, Pin hole test. Keywords: tape wrapped round copper winding wire of temperature index 220, aromatic polyamide (aramid) tape