EN 60060-3:2006/corrigendum Oct. 2006

FOREWORD
INTRODUCTION
1 Scope
2 Normative references
3 Terms and definitions
4 Common tests and checks on a measuring system
   4.1 Acceptance test
   4.2 Performance test
   4.3 Performance check
   4.4 Record of performance
5 Tests with direct voltage
   5.1 General
   5.2 Definitions for direct voltage tests
   5.3 Test voltage
   5.4 Measurement of the test voltage
   5.5 Tests and checks on measuring systems
   5.6 Withstand voltage test procedure
6 Tests with alternating voltage
   6.1 General
   6.2 Definitions for alternating voltage tests
   6.3 Test voltage
   6.4 Measurement of the test voltage
   6.5 Tests and checks on measuring systems
   6.6 Withstand voltage test procedure
7 Tests with lightning impulse voltage
   7.1 General
   7.2 Definitions for lightning impulse voltage tests
   7.3 Test voltage
   7.4 Measurement of the test voltage and determination
        of the impulse voltage shape
   7.5 Tests and checks on measuring systems
   7.6 Withstand voltage test procedures
8 Tests with switching impulse voltage
   8.1 General
   8.2 Definitions for switching impulse voltage tests
   8.3 Test voltage
   8.4 Measurement of the test voltage and determination
        of the impulse shape
   8.5 Tests and checks on measuring systems
   8.6 Withstand voltage test procedures
9 Tests with very low frequency voltages
   9.1 General
   9.2 Definitions for very low frequency voltage tests
   9.3 Test voltage
   9.4 Measurement of the test voltage
   9.5 Tests and checks on measuring systems
   9.6 Test procedure
10 Tests with damped alternating voltages
   10.1 General
   10.2 Definitions for damped alternating voltage tests
   10.3 Test voltage
   10.4 Measurement of the test voltage
   10.5 Tests and checks on measuring systems
   10.6 Test procedure
Annex ZA (normative) Normative references to international
         publications with their corresponding European
         publications

Applies to the following on-site test voltages and in service stresses, which are in relation to IEC 60060-1: - direct voltage; - alternating voltage; - lightning impulse voltage of aperiodic or oscillating shape; - switching impulse voltage of aperiodic or oscillating shape.