EN 50131-2-5:2008

Introduction
1 Scope
2 Normative references
3 Definitions and abbreviations
4 Functional requirements
5 Marking, identification and documentation
6 Testing
Annex A (normative) - Dimensions & requirements
        of the standardised test magnets
Annex B (normative) - General testing matrix
Annex C (informative) - Walk test diagrams
Annex D (normative) - Procedure for calculation of
        average temperature difference
Annex E (informative) - Basic detection target for the
        basic test of detection capability
Annex F (informative) - Equipment for walk test velocity control
Annex G (informative) - Immunity to visible and near infrared
        radiation - Notes on calibration of the light source
Annex H (informative) - Example list of small tools
Annex I (informative) - Test for resistance to re-orientation
        of adjustable mountings
Bibliography

This European Standard is for combined passive infrared and ultrasonic detectors installed in buildings and provides for security grades 1 to 4 (see EN 50131-1), specific or non-specific wired or fire-free detectors, and uses environmental classes I to IV (see EN 50130-5). This standard does not include requirements for combined passive infra red and ultrasonic detectors intended for use outdoors. A detector shall fulfil all the requirements of the specified grade. Functions additional to the mandatory functions specified in this standard may be included in the detector, providing they do not influence the correct operation of the mandatory functions. The European Standard does not apply to system interconnections.