EN 50131-2-4:2008

Introduction
1 Scope
2 Normative references
3 Definitions and abbreviations
4 Functional requirements
5 Marking, identification and documentation
6 Testing
Annexes
Annex A (normative) - Dimensions & Requirements
        of the standardised Test Magnets
Annex B (normative) - General testing matrix
Annex C (normative) - Walk test diagrams
Annex D (normative) - Procedure for calculation of
        the average temperature difference between the
        standard target and the background
Annex E (informative) - Basic detection target for the
        basic test of detection capability
Annex F (informative) - Equipment for walk test
        velocity control
Annex G (informative) - Immunity to visible and near
        Infrared radiation - Notes on calibration of the
        light source
Annex H (informative) - Immunity to microwave signal
        interference by fluorescent lights
Annex I (informative) - Example list of small tools
Annex J (informative) - Test for resistance to re-orientation
        of adjustable mountings

This standard is for combined passive infrared and microwave detectors installed in buildings and provides for security Grades 1 to 4 (see EN 50131-1), specific or non-specific wired or wire-free detectors, and uses environmental classes I to IV (see EN 50130-5). This standard does not include requirements for detectors intended for use outdoors. A detector shall fulfil all the requirements of the specified grade. Function additional to the mandatory functions specified in this standard may be included in the detector, providing they do not influence the correct operation of the mandatory functions. This European Standard does not apply to system interconnections.