EN 14315-1:2013

Foreword
1 Scope
2 Normative references
3 Terms, definitions, symbols and abbreviations
4 Requirements
5 Test methods
6 Designation code
7 Evaluation of conformity
8 Marking, labelling and technical information
Annex A (normative) - Determination of declared aged
        thermal conductivity and aged thermal
        resistance
Annex B (normative) - Initial type testing (ITT) and
        Factory production control (FPC)
Annex C (normative) - Determination of the aged values
        of thermal resistance and thermal conductivity
Annex D (normative) - Preparation of the test sample
Annex E (normative) - Determination of the reaction
        profile and free-rise density
Annex F (normative) - Determination of substrate adhesion
        strength perpendicular to faces
Annex G (normative) - Testing for reaction to fire products
Annex H (normative) - Testing for reaction to fire products
        in standardised assemblies simulating end-use
        application(s)
Annex I (informative) - Example for the determination of
        the declared aged values of thermal conductivity and
        thermal resistance for a product
Annex J (normative) - Instructions for compiling thermal
        resistance performance charts
Annex ZA (informative) - Clauses of this European Standard
         addressing the provisions of the EU Construction
         Products Directive
Bibliography

This European Standard specifies requirements for in-situ formed sprayed rigid polyurethane (PUR) and rigid polyisocyanurate (PIR) foam products when applied to walls, ceilings, roofs, suspended ceilings and floors.This Part 1 of this European Standard is a specification for the rigid foam spray system before installation.Part 1 of this European Standard describes the product characteristics and includes procedures for testing, marking and labelling and the rules for evaluation of conformity.This European Standard does not specify the required levels of all properties to be achieved by a product to demonstrate fitness for purpose in a particular end-use application. The required levels are to be found in regulations or non-conflicting standards.This European Standard does not cover factory made rigid polyurethane (PUR) or polyisocyanurate (PIR) foam insulation products or in-situ products intended to be used for the insulation of building equipment and industrial installations.NOTEFoam products are either called flexible or rigid. The flexible products are used in upholstery and mattresses and are characterised by their ability to deflect, support and recover to their original thickness continually during their in-use phase. Those that are not flexible are termed rigid and do not possess these flexible characteristics. They are mostly used for thermal insulation purposes and vary widely in their compression strength values. Once the cell structure is crushed in a rigid foam, it does not recover its thickness fully. Some of these rigid foams are very low in density with very low compression strengths and are sometimes described "commercially" as "soft foams" or "semi-rigid" foams. This note has been included to clarify that all foams with such descriptions are covered by this standard’s used of the term rigid foam.