EN 1363-1:2012

Foreword
Introduction
1 Scope
2 Normative references
3 Terms, definitions, symbols and designations
4 Test equipment
5 Test conditions
6 Test specimen(s)
7 Installation of test specimen
8 Conditioning
9 Application of instrumentation
10 Test procedure
11 Performance criteria
12 Test report
Annex A (informative) - Field of application
        of test results
Annex B (informative) - The role of supporting
        constructions
Annex C (informative) - General information on
        thermocouples
Annex D (informative) - Guidance on the basis for
        selection of the test load
Annex E (informative) - Boundary and support
        conditions
Annex F (informative) - Guidance on conditioning
Annex G (informative) - Guidance on deflection
        measurements of vertical separating elements
        using a fixed datum
Bibliography

This European Standard establishes the general principles for determining the fire resistance of various elements of construction when subjected to standard fire exposure conditions. Alternative and additional procedures to meet special requirements are given in EN 1363-2.The principle that has been embodied within all European Standards relating to fire resistance testing is that where aspects and procedures of testing are common to all specific test methods e.g. the temperature/time curve, then they are specified in this test method. Where a general principle is common to many specific test methods but the details vary according to the element being tested (e.g. the measurement of unexposed face temperature), then the principle is given in this document, but the details are given in the specific test method. Where certain aspects of testing are unique to a particular specific test method (e.g. the air leakage test for fire dampers), then no details are included in this document.The test results obtained might be directly applicable to other similar elements, or variations of the element tested. The extent to which this application is permitted depends upon the field of direct application of the test result. This is restricted by the provision of rules which limit the variation from the tested specimen without further evaluation. The rules for determining the permitted variations are given in each specific test method.Variations outside those permitted by direct application are covered under extended application of test results. This results from an in-depth review of the design and performance of a particular product in test(s) by a recognised authority. Further consideration on direct and extended application is given in Annex A.The duration for which the tested element, as modified by its direct or extended field of application, satisfies specific criteria will permit subsequent classification.All values given in this Standard are nominal unless otherwise specified.