EN 1329-1:2014+A1:2018

Foreword
1 Scope
2 Normative references
3 Terms and definitions, symbols and abbreviations
4 Material
5 General characteristics
6 Geometrical characteristics
7 Mechanical characteristics
8 Physical characteristics
9 Performance requirements
10 Sealing rings
11 Adhesives
12 Marking
Annex A (normative) - Utilization of non-virgin
        material
Annex B (informative) - Product standards
Annex C (informative) - Correspondence between
        ISO test methods and CEN test methods
Bibliography

This document specifies the requirements for solid wall pipes with smooth internal and external surfaces, extruded from the same formulation throughout the wall, fittings and the system of unplasticized poly(vinyl chloride) (PVC U) piping systems in the field of non-pressure underground drainage and sewerage:- buried in ground outside the building structure (application area code "U"), and- both buried in ground, within the building structure and outside the building (application area code "UD").NOTE 1The intended use is reflected in the marking of products by "U" or "UD".It also specifies the test parameters for the test methods referred to in this document.NOTE 2Multilayer pipes with different formulations throughout the wall and foamed core pipes are covered by EN 13476-2 [1]. This document covers a range of nominal sizes, a range of pipes and fittings series and a range of stiffness classes and gives recommendations concerning colours.NOTE 3It is the responsibility of the purchaser or specifier to make the appropriate selection from these aspects, taking into account their particular requirements and any relevant national regulations and installation practices or codes.It is applicable to PVC U pipes and fittings, their joints and to joints with components of other plastics and non-plastics materials intended to be used for buried piping systems for non-pressure underground drainage and sewerage.NOTE 4Pipes, fittings and other components conforming to any of the plastics product standards listed in Annex C can be used with pipes and fittings conforming to this document, provided they conform to the requirements for joint dimensions given in Clause 7 and to the requirements of Table 16.