EN 12312-8:2005+A1:2009
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Aircraft ground support equipment - Specific requirements - Part 8: Maintenance stairs and platforms
02-22-2022
04-29-2009
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 List of hazards
5 Safety requirements and/or measures
5.1 General requirements
5.2 Stair flight
5.3 Platforms
5.4 Guard rails
5.5 Lifting devices
5.6 Controls, monitoring devices and displays
5.7 Auxiliary means for powered maintenance stairs
and platforms
6 Information for use
6.1 Marking
6.2 Additional marking
6.3 Warnings
6.4 Instructions
7 Verification of requirements
Annex A (informative) - Examples of typical maintenance
stairs and platforms
Annex B (normative) - List of hazards in addition to those
of EN 1915-1
Annex ZA (informative) - Relationship between this European
Standard and the Essential Requirements of EU Directive
98/37/EC, amended by Directive 98/79/EC
Annex ZB (informative) - Relationship between this European
Standard and the Essential Requirements of EU Directive
2006/42/EC
Bibliography
This European Standard specifies the technical requirements to minimise the hazards listed in Clause 4 which can arise during the commissioning, operation and maintenance of maintenance stairs and platforms when carried out in accordance with the specifications given by the manufacturer or his authorised representative. It also takes into account some performance requirements recognised as essential by authorities, aircraft and ground support equipment (GSE) manufacturers as well as airlines and maintenance and handling agencies.This European Standard applies to:-self-propelled maintenance stairs and platforms;-towable maintenance stairs and platforms equipped with powered means, e.g. for height adjustment, stabilizers,designed for aircraft maintenance purposes including access to the aircraft (Examples see Annex A).NOTE 1Powered should be also understood as manual effort stored in springs or hydraulic accumulators, etc., the dangerous action of which can be produced or can continue after the manual effort has ceased or directly applied manual effort for lifting or lowering loads.NOTE 2Those clauses of this European Standard that can apply may also be used as a guideline for the design of towable maintenance stairs and platforms without powered means.This European Standard does not apply to:-maintenance docks either fixed to the ground or moveable only for docking procedure.This European Standard does not establish requirements for noise and vibration.Noise and vibration are dealt with respectively in EN 1915-4 and EN 1915-3.This European Standard does not deal with hazards in respect to a standard automotive chassis and from other vehicles on the apron.This Part of EN 12312 is not applicable to maintenance stairs and platforms which are manufactured before the date of publication of this standard by CEN.This part of EN 12312 is intended to be used in conjunction with EN 1915-1, EN 1915-2, EN 1915-3 (for vehicles) and EN 1915-4.
Committee |
CEN/TC 274
|
DevelopmentNote |
2005 Edition Re-Issued in April 2009 & incorporates AMD 1 2009. (06/2009)
|
DocumentType |
Standard
|
PublisherName |
Comite Europeen de Normalisation
|
Status |
Superseded
|
SupersededBy |
Standards | Relationship |
DS EN 12312-8:2018 | Identical |
DS EN 12312-8 : 2005 + A1 2009 | Identical |
NBN EN 12312-8 : 2005 + A1 2009 | Identical |
NF EN 12312-8 : 2005 + A1 2010 | Identical |
NS EN 12312-8 : 2005 + A1 2009 | Identical |
NEN EN 12312-8:2018 EN | Identical |
BS EN 12312-8 : 2005 | Identical |
NEN EN 12312-8 : 2005 + A1 2009 | Identical |
I.S. EN 12312-8:2018 | Identical |
DIN EN 12312-8:2018-10 | Identical |
SN EN 12312-8 : 2005 + A1 2009 | Identical |
I.S. EN 12312-8:2005 | Identical |
ONORM EN 12312-8 : 2009 | Identical |
SS EN 12312-8:2018 | Identical |
UNI EN 12312-8 : 2018 | Identical |
PN EN 12312-8 : 2007 + A1 2010 | Identical |
BS EN 12312-8:2018 | Identical |
UNI EN 12312-8 : 2010 | Identical |
ÖNORM EN 12312-8:2018 | Identical |
DIN EN 12312-8:2015-07 (Draft) | Identical |
UNE-EN 12312-8:2005+A1:2009 | Identical |
BS EN 12312-12:2017 | Aircraft ground support equipment. Specific requirements Potable water service equipment |
BS EN 12312-13:2017 | Aircraft ground support equipment. Specific requirements Lavatory service equipment |
EN 12312-13:2017 | Aircraft ground support equipment - Specific requirements - Part 13: Lavatory service equipment |
EN 12312-12:2017 | Aircraft ground support equipment - Specific requirements - Part 12: Potable water service equipment |
I.S. EN 12312-12:2017 | AIRCRAFT GROUND SUPPORT EQUIPMENT - SPECIFIC REQUIREMENTS - PART 12: POTABLE WATER SERVICE EQUIPMENT |
UNE-EN 12312-12:2018 | Aircraft ground support equipment - Specific requirements - Part 12: Potable water service equipment |
UNE-EN 12312-13:2018 | Aircraft ground support equipment - Specific requirements - Part 13: Lavatory service equipment |
CEN Guide 414:2017 | Safety of machinery - Rules for the drafting and presentation of safety standards |
EN 280:2013+A1:2015 | Mobile elevating work platforms - Design calculations - Stability criteria - Construction - Safety - Examinations and tests |
EN 1915-3:2004+A1:2009 | Aircraft ground support equipment - General requirements - Part 3: Vibration measurement methods and reduction |
EN 1837:1999+A1:2009 | Safety of machinery - Integral lighting of machines |
EN ISO 13850:2015 | Safety of machinery - Emergency stop function - Principles for design (ISO 13850:2015) |
EN 1175-1:1998+A1:2010 | Safety of industrial trucks - Electrical requirements - Part 1: General requirements for battery powered trucks |
EN 1050 : 1996 | SAFETY OF MACHINERY - PRINCIPLES FOR RISK ASSESSMENT |
EN 1915-4:2004+A1:2009 | Aircraft ground support equipment - General requirements - Part 4: Noise measurement methods and reduction |
EN 1915-2:2001+A1:2009 | Aircraft ground support equipment - General requirements - Part 2: Stability and strength requirements, calculations and test methods |
ISO 12100-2:2003 | Safety of machinery Basic concepts, general principles for design Part 2: Technical principles |
ISO 12100-1:2003 | Safety of machinery Basic concepts, general principles for design Part 1: Basic terminology, methodology |
ISO 13850:2015 | Safety of machinery Emergency stop function Principles for design |
EN 1915-1:2013 | Aircraft ground support equipment - General requirements - Part 1: Basic safety requirements |
EN 1386:2007 | Aluminium and aluminium alloys - Tread plate - Specifications |
1998/37/EC : 1998 | DIRECTIVE 98/37/EC OF THE EUROPEAN PARLIAMENT AND OF THE COUNCIL OF 22 JUNE 1998 ON THE APPROXIMATION OF THE LAWS OF THE MEMBER STATES RELATING TO MACHINERY |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.