DEFSTAN 00-970(PT1)SEC7/9(2013) : 2013
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
DESIGN AND AIRWORTHINESS REQUIREMENTS FOR SERVICE AIRCRAFT - PART 1: FIXED WING - SECTION 7: OPERATING LIMITATIONS AND INFORMATION
Hardcopy , PDF
07-05-2013
English
01-01-2013
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Preface
SECTION 7 - OPERATING LIMITATIONS
7.0 Introduction
7.1 Operating Instructions
7.2 Climatic Conditions
7.3 Aircraft Performance and limitations
7.4 Operational Colouring and Markings
7.5 Publication of Aircraft Performance
7.6 Electronic Cockpit Documentation
SUPPLEMENTS
Section 7 - Leaflets 0 to 3
Describes the basic operational limitations for general application in the design of aircraft but are not applicable in the case of take-off and landing requirements for VSTOL aeroplanes.
| DevelopmentNote |
Supersedes DEFSTAN 00-970(PT1)SEC7/8(2012). (02/2013)
|
| DocumentType |
Standard
|
| Pages |
68
|
| PublisherName |
UK Ministry of Defence Standards
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
| DEFSTAN 00-35(PT4)/4(2006) : 2006 | ENVIRONMENTAL HANDBOOK FOR DEFENCE MATERIEL - PART 4: NATURAL ENVIRONMENTS |
| DEFSTAN 00-35(PT5)/4(2006) : 2006 | ENVIRONMENTAL HANDBOOK FOR DEFENCE MATERIEL - PART 5: INDUCED MECHANICAL ENVIRONMENTS |
| DEFSTAN 05-18/5(2007) : 2007 | SYMBOL MARKINGS OF SERVICING AND SAFETY/HAZARD POINTS ON AIRCRAFT, GROUND SUPPORT EQUIPMENT AND GUIDED WEAPONS SYSTEMS |
| DEFSTAN 00-35(PT1)/4(2006) : 2006 | ENVIRONMENTAL HANDBOOK FOR DEFENCE MATERIEL - PART 1: CONTROL AND MANAGEMENT |
| DEFSTAN 05-56/1(1980) : 1980 | GRAPHICAL SYMBOLS FOR AIRCRAFT HYDRAULIC AND PNEUMATIC SYSTEMS |
| DEFSTAN 00-35(PT3)/4(2006) : 2006 | ENVIRONMENTAL HANDBOOK FOR DEFENCE MATERIEL - PART 3: ENVIRONMENTAL TEST METHODS |
| DEFSTAN 16-21/2(1986) : 1986 AMD 1 1986 | MARKING OF AIRCRAFT HYDRAULIC COMPONENTS |
| BS G 198-5:1997 | Sleeves and moulded components for aircraft electric cables and equipment wires Specification for heat shrinkable moulded shapes |
| DEFSTAN 61-6/3(1989) : 1989 | AIRCRAFT ELECTRICAL CIRCUIT IDENTIFICATION |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.