BS ISO 20267:2017
Current
The latest, up-to-date edition.
Thermal spraying. Determination of interfacial toughness of ceramic coatings by indentation
Hardcopy , PDF
English
07-06-2017
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Symbols and units
5 Principle
6 Test pieces and sample preparation
7 Apparatus
8 Procedure and conditions of testing
9 Evaluation of indentation interfacial toughness
10 Test report
Bibliography
Describes a method for measuring the interfacial toughness of thermal spray ceramic coatings at room temperature based on an indentation method.
| Committee |
STI/40
|
| DevelopmentNote |
Supersedes 16/30319126 DC. (07/2017)
|
| DocumentType |
Standard
|
| Pages |
22
|
| PublisherName |
British Standards Institution
|
| Status |
Current
|
| Supersedes |
This document specifies a method for measuring the interfacial toughness of thermal spray ceramic coatings at room temperature based on an indentation method. The interfacial toughness is calculated from the mean length of cracks emanating from the corners of the impression induced by a Vickers hardness tester, and it is intended for use with ceramic coatings with a single layer or multilayers. The test procedures proposed in this document are intended for use in an ambient environment.
This document is recommended for thermal spray ceramic coatings such as thermal barrier coatings, wear resistant coatings and electrical insulating coatings.
| Standards | Relationship |
| ISO 20267:2017 | Identical |
| ISO 6507-1:2005 | Metallic materials Vickers hardness test Part 1: Test method |
| ISO 14577-4:2016 | Metallic materials Instrumented indentation test for hardness and materials parameters Part 4: Test method for metallic and non-metallic coatings |
| ISO 6507-2:2005 | Metallic materials Vickers hardness test Part 2: Verification and calibration of testing machines |
| ISO 14916:2017 | Thermal spraying — Determination of tensile adhesive strength |
| ISO 19477:2016 | Metallic and other inorganic coatings Measurement of Young's modulus of thermal barrier coatings by beam bending |
| ISO 17561:2016 | Fine ceramics (advanced ceramics, advanced technical ceramics) — Test method for elastic moduli of monolithic ceramics at room temperature by sonic resonance |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.