BS ISO 18535:2016
Current
The latest, up-to-date edition.
Diamond-like carbon films. Determination of friction and wear characteristics of diamond-like carbon films by ball-on-disc method
03-31-2016
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Test materials and specimen preparation
5 Apparatus
6 Testing procedure
7 Calculation of test results
8 Test report
Annex A (informative) - Uncertainty of measurement for
calculating of coefficient of friction
Bibliography
Describes a procedure for and provides guidance on the determination of the coefficient of friction and the specific wear rate of diamond-like carbon (DLC) films.
| Committee |
STI/33
|
| DevelopmentNote |
Supersedes 15/30279088 DC. (04/2016)
|
| DocumentType |
Standard
|
| PublisherName |
British Standards Institution
|
| Status |
Current
|
| Supersedes |
This International Standard specifies a procedure for and provides guidance on the determination of the coefficient of friction and the specific wear rate of diamond-like carbon (DLC) films. The method specifies that the materials are tested under dry conditions in pairs in a ball-on-disc configuration.
The results of the tests are not applicable when DLC-coated parts operate in a lubricated environment.
| Standards | Relationship |
| ISO 18535:2016 | Identical |
| ISO 4287:1997 | Geometrical Product Specifications (GPS) — Surface texture: Profile method — Terms, definitions and surface texture parameters |
| ISO 3290-1:2014 | Rolling bearings Balls Part 1: Steel balls |
| ISO 20808:2016 | Fine ceramics (advanced ceramics, advanced technical ceramics) Determination of friction and wear characteristics of monolithic ceramics by ball-on-disc method |
| ISO/IEC Guide 98-1:2009 | Uncertainty of measurement — Part 1: Introduction to the expression of uncertainty in measurement |
| ISO 1101:2017 | Geometrical product specifications (GPS) — Geometrical tolerancing — Tolerances of form, orientation, location and run-out |
| ISO 13385-2:2011 | Geometrical product specifications (GPS) Dimensional measuring equipment Part 2: Calliper depth gauges; Design and metrological characteristics |
| ISO 13385-1:2011 | Geometrical product specifications (GPS) Dimensional measuring equipment Part 1: Callipers; Design and metrological characteristics |
| ISO 3274:1996 | Geometrical Product Specifications (GPS) — Surface texture: Profile method — Nominal characteristics of contact (stylus) instruments |
| ASTM G 99 : 2017 : REDLINE | Standard Test Method for Wear Testing with a Pin-on-Disk Apparatus |
| ISO 80000-1:2009 | Quantities and units — Part 1: General |
| ISO 3290-2:2014 | Rolling bearings Balls Part 2: Ceramic balls |
| ISO 3611:2010 | Geometrical product specifications (GPS) — Dimensional measuring equipment: Micrometers for external measurements — Design and metrological characteristics |
| DIN 50324:1992-07 | TRIBOLOGY; TESTING OF FRICTION AND WEAR MODEL TEST FOR SLIDING FRICTION OF SOLIDS (BALL ON DISC SYSTEM) |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.