BS ISO 11403-1 : AMD 10683
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
PLASTICS - ACQUISITION AND PRESENTATION OF COMPARABLE MULTIPOINT DATA - MECHANICAL PROPERTIES
09-15-2000
11-23-2012
Gives procedures for testing the acquisition and presentation of multipoint data on the following mechanical plastics: Dynamic modulus, tensile properties at constant test speed, ultimate stress and strain, tensile stress-strain curves, tensile creep and charpy impact strength. Mainly applicable to plastics which can be injection-or compression-moulded or prepared as sheets of specified thickness from which appropriately-sized specimens can be machined.
| Committee |
PRI/21
|
| DevelopmentNote |
Superseded and renumbered by BS EN ISO 11403-1 (09/2000)
|
| DocumentType |
Standard
|
| PublisherName |
British Standards Institution
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
| Standards | Relationship |
| ISO 11403-1:2014 | Identical |
| ISO 6721-2:2008 | Plastics Determination of dynamic mechanical properties Part 2: Torsion-pendulum method |
| ISO 293:2004 | Plastics — Compression moulding of test specimens of thermoplastic materials |
| ISO 3167:2014 | Plastics Multipurpose test specimens |
| ISO 295:2004 | Plastics — Compression moulding of test specimens of thermosetting materials |
| ISO 294:1995 | Plastics Injection moulding of test specimens of thermoplastic materials |
| ISO 10350:1993 | Plastics Acquisition and presentation of comparable single-point data |
| ISO 527-2:2012 | Plastics — Determination of tensile properties — Part 2: Test conditions for moulding and extrusion plastics |
| ISO 6721-4:2008 | Plastics Determination of dynamic mechanical properties Part 4: Tensile vibration Non-resonance method |
| ISO 179:1993 | Plastics Determination of Charpy impact strength |
| ISO 2818:1994 | Plastics — Preparation of test specimens by machining |
| ISO 899-1:2017 | Plastics — Determination of creep behaviour — Part 1: Tensile creep |
| ISO 10724:1994 | Plastics — Thermosetting moulding materials — Injection moulding of multipurpose test specimens |
| ISO 527-1:2012 | Plastics Determination of tensile properties Part 1: General principles |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.