BS EN ISO 17078-2:2007

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Symbols and abbreviated terms
  4.1 Abbreviations
  4.2 Symbols and engineering terms
5 Functional specification
  5.1 General
  5.2 Functional characteristics
  5.3 Well parameters
  5.4 Operational parameters
  5.5 Compatibility with well-related equipment
  5.6 Environmental service classes
  5.7 Design validation grades
  5.8 Product functional testing grades
  5.9 Quality control grades
  5.10 Additional required testing
6 Technical specification
  6.1 General requirements
  6.2 Technical characteristics
  6.3 Design criteria
  6.4 Allowable design changes
  6.5 Design verification and validation requirements
  6.6 Product functional testing requirements
7 Supplier/manufacturer requirements
  7.1 General
  7.2 Documentation and data control
  7.3 Product identification requirements
  7.4 Quality control requirements
  7.5 Heat-treating-equipment qualification
  7.6 Welding requirements
  7.7 Non-destructive examination requirements
  7.8 Storage and shipping preparation
  7.9 Allowable changes after manufacturing
  7.10 Reconditioning of flow-control devices
Annex A (normative) - Design validation and product
                      functional testing requirements
Annex B (normative) - Environmental service classes
Annex C (normative) - Design validation grades
Annex D (normative) - Product functional testing grades
Annex E (normative) - Interface testing requirements
Annex F (normative) - Insertion testing requirements
Annex G (normative) - Probe and travel testing and load
                      rate determination
Annex H (normative) - Dynamic flow testing and flow
                      coefficient calculation
Annex I (normative) - Back-check testing
Annex J (normative) - Opening and closing pressure testing
Annex K (normative) - Bellows actuation life cycle testing
Annex L (normative) - Erosion testing requirements
Annex M (normative) - Shelf (bellows integrity) testing
                      requirements for nitrogen-pressure-charged
                      flow-control devices
Annex N (normative) - Conducting port/seat leakage rate testing
Annex O (informative) - Performance testing - Recommendations
                        for a flow-control device performance
                        test facility
Annex P (informative) - Performance testing - Prediction
                        correlations using a simplified flow
                        control device performance model
Bibliography

Specifies requirements for subsurface flow-control devices used in side-pocket mandrels (hereafter called flow-control devices) intended for use in the worldwide petroleum and natural gas industry.