BS EN ISO 15530-3:2011
Current
The latest, up-to-date edition.
Geometrical product specifications (GPS). Coordinate measuring machines (CMM). Technique for determining the uncertainty of measurement Use of calibrated workpieces or measurement standards
Hardcopy , PDF
English
10-31-2011
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Symbols
5 Requirements
6 Principle of the uncertainty evaluation using calibrated
workpieces
7 Procedure
8 Reverification of the measurement uncertainty
9 Interim check of the measurement uncertainty
Annex A (informative) - Examples of application
Annex B (informative) - Relation to the GPS matrix model
Bibliography
Describes the evaluation of measurement uncertainty for results of measurements obtained by a CMM (coordinate measuring machine) and by using calibrated workpieces or measurement standards.
| Committee |
TPR/1
|
| DevelopmentNote |
Supersedes DD CEN ISO/TS 15530-3 and 09/30198173 DC. (10/2011)
|
| DocumentType |
Standard
|
| Pages |
30
|
| PublisherName |
British Standards Institution
|
| Status |
Current
|
| Supersedes | |
| UnderRevision |
This part of ISO15530 specifies the evaluation of measurement uncertainty for results of measurements obtained by a CMM (coordinate measuring machine) and by using calibrated workpieces or measurement standards. It provides an experimental technique for simplifying the uncertainty evaluation of CMM measurements, whose approach (substitution measurements) leads to measurements being carried out in the same way as actual measurements, but with calibrated workpieces of similar dimension and geometry instead of the unknown workpieces to be measured.
Non-substitution measurements on CMMs are also covered, as are the requirements of the uncertainty evaluation procedure, the measurement equipment needed, and the reverification and interim check of the measurement uncertainty.
NOTE The evaluation of measurement uncertainty is always related to a specific measuring task.
| Standards | Relationship |
| ISO 15530-3:2011 | Identical |
| EN ISO 15530-3:2011 | Identical |
| ISO/TR 14638:1995 | Geometrical product specification (GPS) Masterplan |
| ISO 8015:2011 | Geometrical product specifications (GPS) Fundamentals Concepts, principles and rules |
| ISO 10360-1:2000 | Geometrical Product Specifications (GPS) — Acceptance and reverification tests for coordinate measuring machines (CMM) — Part 1: Vocabulary |
| ISO 14978:2006 | Geometrical product specifications (GPS) General concepts and requirements for GPS measuring equipment |
| ISO 14253-1:2017 | Geometrical product specifications (GPS) — Inspection by measurement of workpieces and measuring equipment — Part 1: Decision rules for verifying conformity or nonconformity with specifications |
| ISO/IEC Guide 99:2007 | International vocabulary of metrology Basic and general concepts and associated terms (VIM) |
| ISO/IEC Guide 98-3:2008 | Uncertainty of measurement — Part 3: Guide to the expression of uncertainty in measurement (GUM:1995) |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.