BS EN ISO 13628-15:2011

Foreword
1 Scope
2 Normative references
3 Terms, abbreviated terms, and definitions
4 Manifold and template functional considerations
5 Design considerations
6 Verification and validation of design
7 Materials and fabrication requirements to piping systems
8 Fabrication and manufacturing considerations
9 Installation, operation and maintenance considerations
10 ROV/ROT aspects
11 Lifting considerations
12 Equipment marking
13 Transportation and storage
14 Abandonment provisions
Annex A (informative) - Typical manifold data sheet
Bibliography

Specifies recommendations for subsea structures and manifolds, within the frameworks set forth by recognized and accepted industry specifications and standards.

This part of ISO13628 addresses recommendations for subsea structures and manifolds, within the frameworks set forth by recognized and accepted industry specifications and standards. As such, it does not supersede or eliminate any requirement imposed by any other industry specification. This part of ISO13628 covers subsea manifolds and templates utilized for pressure control in both subsea production of oil and gas, and subsea injection services. See Figure1 for an example of such a subsea system. Equipment within the scope of this part of ISO13628 is listed below: the following structural components and piping systems of subsea production systems: production and injection manifolds, modular and integrated single satellite and multiwell templates, subsea processing and subsea boosting stations, flowline riser bases and export riser bases (FRB, ERB), pipeline end manifolds (PLEM), pipeline end terminations (PLET), T- and Y-connection, subsea isolation valve (SSIV); the following structural components of subsea production system: subsea controls and distribution structures, other subsea structures; protection structures associated with the above. The following components and their applications are outside the scope of this part of ISO13628: pipeline and manifold valves; flowline and tie-in connectors; choke valves; production control systems. NOTE General information regarding these topics can be found in additional publications, such as ISO13628-1 and API Spec 2C. Figure1 Example of some typical subsea structures Key A tree B cluster manifold C PLEM D PLET E inline tee F multi-phase pump skid