BS EN 62841-3-10:2015

FOREWORD
1 Scope
2 Normative references
3 Terms and definitions
4 General requirements
5 General conditions for the tests
6 Radiation, toxicity and similar hazards
7 Classification
8 Marking and instructions
9 Protection against access to live parts
10 Starting
11 Input and current
12 Heating
13 Resistance to heat and fire
14 Moisture resistance
15 Resistance to rusting
16 Overload protection of transformers and associated circuits
17 Endurance
18 Abnormal operation
19 Mechanical hazards
20 Mechanical strength
21 Construction
22 Internal wiring
23 Components
24 Supply connection and external flexible cords
25 Terminals for external conductors
26 Provision for earthing
27 Screws and connections
28 Creepage distances, clearances and distances through
  insulation
Annexes
Annex I (normative) - Measurement of noise and vibration
        emissions
Annex K (normative) - Battery tools and battery packs
Bibliography
Annex ZA (normative) - Normative references to
         international publications with their
         corresponding European publications
Annex ZZ (informative) - Coverage of Essential
         Requirements of Directive 2006/42/EC

Pertains to transportable cut-off machines intended to cut materials such as metals, concrete and masonry and to be fitted with one abrasive - bonded reinforced wheel of Type 41, or - diamond cut-off wheel with the peripheral gaps, if any, not exceeding 10 mm and with - a rated no-load speed not exceeding a peripheral speed of the wheel of 100 m/s with the maximum wheel diameter and - a wheel diameter range of 250 mm to 410 mm.

This clause of Part1 is applicable, except as follows: Addition: This part of IEC62841 applies to transportable cut-off machines intended to cut materials such as metals, concrete and masonry and to be fitted with one abrasive bonded reinforced wheel of Type41, or diamond cut-off wheel with the peripheral gaps, if any, not exceeding 10mm and with a rated no-load speed not exceeding a peripheral speed of the wheel of 100m/s with the maximum wheel diameter and a wheel diameter range of 250mm to 410mm. This standard does not apply to: transportable mitre saws; transportable tile saws; transportable metal saws. NOTE101 Transportable mitre saws are covered by IEC62841‑3‑9 . Transportable tile saws will be covered by a future part of IEC62841‑3 . Transportable metal saws will be covered by a future part of IEC62841‑3 .