BS EN 60706-3:2006

INTRODUCTION
1 Scope
2 Normative references
3 Terms and definitions
4 Introduction to maintainability verification
  4.1 Objective of verification
  4.2 Maintenance support concepts influencing maintainability
      verification
  4.3 Methods of verification
  4.4 Verification process
  4.5 Conditions and constraints
  4.6 Qualitative and quantitative verification procedures
5 Procedures for verification of qualitative maintainability
  5.1 Design review
  5.2 Review of test experience
  5.3 Ease-of-maintenance studies
  5.4 Review of maintenance task analysis
  5.5 Review of operational experience
6 Procedures for verification of quantitative maintainability
  6.1 Maintainability predictions
  6.2 Verification based on demonstration tests
  6.3 Verification based on field data
7 Demonstration procedures
  7.1 General
  7.2 Demonstration process
  7.3 Demonstration planning
  7.4 Conditions and constraints
  7.5 Demonstration after modification
8 Elements of the verification procedure
  8.1 Utilization of data sources
  8.2 Data acquisition and analysis
  8.3 Evaluation
  8.4 Comparison
9 Collection, analysis and presentation of maintainability data
  9.1 General
  9.2 Maintenance concept
  9.3 Data sources
  9.4 Item demonstration and field data
  9.5 Analysis procedures
  9.6 Data presentation
Annex A (normative) Maintainability demonstration procedures
Annex B (normative) Maintainability demonstration test methods
Annex C (normative) Analysis of maintainability related data
Annex ZA (normative) Normative references to international
         publications with their corresponding European
         publications
Bibliography

Describes the various aspects of verification necessary to ensure that the specified maintainability requirements of an item have been met and provides suitable procedures and test methods.

This part of IEC 60706 describes the various aspects of verification necessary to ensure that the specified maintainability requirements of an item have been met and provides suitable procedures and test methods. This standard also addresses the collection, analysis and presentation of maintainability related data, which may be required during, and at the completion of, design and during item production and operation.