BS EN 50083-5:2002
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Cabled distribution systems for television and sound signals Headend equipment
Hardcopy , PDF
English
02-06-2002
07-31-2008
1 Scope
1.1 General
1.2 Specific scope of this part 5
2 Normative references
3 Terms, definitions, symbols and abbreviations
3.1 Terms and definitions
3.2 Symbols
3.3 Abbreviation
4 Methods of measurement
4.1 Single-channel intermodulation
4.2 Three-carrier intermodulation measurement
4.3 Two carrier intermodulation measurement for
second and third order products
4.4 Carrier-to-spurious signal ratio at the output
4.5 Television carrier-to-noise ratio
4.6 Differential gain and phase for PAL/SECAM signals
4.7 Group delay variation
4.8 2T-pulse response, K-factor
4.9 Chrominance-luminance delay inequalities
(20T-pulse method)
4.10 Luminance non-linearity
4.11 Intermodulation distortion (FM stereo radio)
4.12 Decoding margin (Teletext)
4.13 Hum modulation of carrier
5 Performance requirements and recommendations
5.1 Safety
5.2 Electromagnetic compatability
5.3 Environmental
5.4 Marking
5.5 Mean time operation between failure (MTBF)
6 Signal requirements
6.1 Indoor units
6.2 Outdoor units
7 Data publication requirements
7.1 General
7.2 Indoor units - TV (AM and FM)
7.3 Indoor units - FM radio
7.4 Outdoor units
Annex A (normative) Definition of the specified test
frequency range for return loss and noise figure
Annex B (normative) Audio connector
Annex C (informative) Selectivity diagram for adjacent
channel transmission
Annex D (normative) Special national conditions
Annex E (informative) Measurement errors which occur due
to mismatched equipment
Defines the characteristics of equipment used in the headends of terrestrial broadcast and satellite receiving systems. Only deals with the interfaces between headend components and only explains the function of the devices if this is necessary to support the description of the interfaces. Coverage includes: group delay variation, single channel intermodulation, luminance non linerarity, signal requirements, data publication requirements, and terms and definitions. Also gives diagrams and annexes.
| Committee |
EPL/100
|
| DevelopmentNote |
Supersedes 97/205214 DC (03/2005)
|
| DocumentType |
Standard
|
| Pages |
58
|
| PublisherName |
British Standards Institution
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
| Standards | Relationship |
| NEN EN 50083-5 : 2001 | Identical |
| EN 50083-5:2001 | Identical |
| NBN EN 50083-5 : 2002 | Identical |
| DIN EN 50083-5 : 2001 | Identical |
| I.S. EN 50083-5:2001 | Identical |
| NF EN 50083-5 : 2002 | Identical |
| UNE-EN 50083-5:2002 | Identical |
| IEC 60417-1:2002 | Graphical symbols for use on equipment - Part 1: Overview and application |
| HD 134.2 : 200S2 | RADIO-FREQUENCY CONNECTORS - COAXIAL UNMATCHED CONNECTOR |
| EN 60068-1:2014 | Environmental testing - Part 1: General and guidance |
| IEC 60169-2:1965 | Radio-frequency connectors. Part 2: Coaxial unmatched connector |
| IEC 60130-9:2011 | Connectors for frequencies below 3 MHz - Part 9: Circular connectors for radio and associated sound equipment |
| EN 60417-1:2002 | GRAPHICAL SYMBOLS FOR USE ON EQUIPMENT - PART 1: OVERVIEW AND APPLICATION |
| EN 50083-3:2002 | Cable networks for television signals, sound signals and interactive services - Part 3: Active wideband equipment for coaxial cable networks |
| EN 50083-2:2012/A1:2015 | CABLE NETWORKS FOR TELEVISION SIGNALS, SOUND SIGNALS AND INTERACTIVE SERVICES - PART 2: ELECTROMAGNETIC COMPATIBILITY FOR EQUIPMENT |
| IEC 60244-5:1992 | Methods of measurement for radio transmitters - Part 5: Performance characteristics of television transmitters |
| EN 60417-2:1999 | Graphical symbols for use on equipment - Part 2: Symbol originals |
| IEC 60529:1989+AMD1:1999+AMD2:2013 CSV | Degrees of protection provided by enclosures (IP Code) |
| IEC 60417-2:1998 | Graphical symbols for use on equipment - Part 2: Symbol originals |
| EN 60130-9:2011 | Connectors for frequencies below 3 MHz - Part 9: Circular connectors for radio and associated sound equipment |
| IEC 60169-8:1978 | Radio-frequency connectors. Part 8: R.F. coaxial connectors with inner diameter of outer conductor 6.5 mm (0.256 in) with bayonet lock - Characteristic impedance 50 ohms (Type BNC) |
| EN 50083-1:1993/A2:1997 | CABLE NETWORKS FOR TELEVISION SIGNALS, SOUND SIGNALS AND INTERACTIVE SERVICES - PART 1: SAFETY REQUIREMENTS |
| EN 60529:1991/AC:2016-12 | DEGREES OF PROTECTION PROVIDED BY ENCLOSURES (IP CODE) (IEC 60529 EDITION 2.2 CORRIGENDUM 2:2015) |
| HD 571 : 200S1 | GENERAL PRINCIPLES FOR THE CREATION OF GRAPHICAL SYMBOLS FOR USE ON EQUIPMENT |
| EN 60244-5:1994 | Methods of measurement for radio transmitters - Part 5: Performance characteristics for television transmitters |
Access your standards online with a subscription
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.
Important note : All end users must be registered with an Account prior to user licenses being assigned.