BS EN 13108-21:2016

European foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Requirements
5 Control procedures
6 Inspection and testing
7 Non-conformity
8 Inspection, measuring and test equipment
9 Records
10 Competence and Training
Annex A (normative) - Tolerances and test frequencies
        for finished bituminous mixtures
Annex B (normative) - Initial inspection and assessment
        of factory and Factory Production Control and
        continuous surveillance of Factory Production Control
        for bituminous mixtures
Annex C (informative) - Additional testing
Annex D (informative) - Special requirements for airfields
Bibliography

Describes both quality and Factory Production Control requirements for use during the manufacture of bituminous mixtures intended for use on roads, airfields and other trafficked areas.

This European Standard specifies both quality and Factory Production Control requirements for use during the manufacture of bituminous mixtures intended for use on roads, airfields and other trafficked areas. Additional testing carried out within contracts is beyond the scope of this European Standard. The Factory Production Control will be applied to European Standards for bituminous mixtures if CE-marking under CPR is applied. It may also be part of quality control in situations where CE-marking does not apply. As such, manufacturers factories’ notified to issue CE Marking for production of bituminous mixtures should not require duplicate or additional auditing for those situations where CE-marking does not apply. This European Standard is applicable to the control of bituminous mixture where the constituents and target composition are known, and have been shown by means of Type Testing to comply with all appropriate specified compositional, performance related or performance based requirements in EN13108‑1to‑7 and EN13108‑9 .