BS EN 13036-4:2011

Foreword
1 Scope
2 Normative references
3 Terms and definitions
4 Safety
5 Principle
6 Test equipment
7 Calibration
8 Additional items required for testing
9 Test Measurements
10 Field sampling
11 Test procedure
12 Calculations
13 Precision
14 Test report
Annex A (normative) - Validation and Calibration
        of the pendulum friction tester
Annex B (informative) - Details of scales
Annex C (informative) - Typical test report
Bibliography

Specifies a method for determining the slip/skid resistance of a surface using a device which remains stationary at the test location.

This European Standard describes a method for determining the slip/skid resistance of a surface using a device which remains stationary at the test location. The slip/skid resistance is measured by means of a slider mounted at the end of a pendulum arm.

The method provides a measure of the slip/skid resistance properties of a surface either in the field or in the laboratory.

This method measures the slip/skid resistance of a small area of a surface (approximately 0,01 m²). This should be considered when deciding its applicability to a surface which may have non-homogeneous surface characteristics, e.g. containing ridges or grooves, or is rough textured (exceeding 1,2 mm mean texture depth).

NOTE As the results from this test are taken at one small location, the results cannot be compared with results from devices e.g. mobile devices, that measure the slip/skid resistance over a long length of a surface.