BS EN 12150-2:2004

Foreword
1 Scope
2 Normative references
3 Terms and definitions
4 Requirements
  4.1 Product description
  4.2 Conformity with the definition of thermally strengthened
      soda lime silicate safety glass
  4.3 Determination of the characteristic's performances
      4.3.1 Characteristics of thermally strengthened soda
            lime silicate safety glass
      4.3.2 Determination of characteristics of thermally
            strengthened soda lime silicate safety glass products
  4.4 Durability
  4.5 Dangerous substances
5 Evaluation of conformity
  5.1 General
  5.2 Initial type testing of the product
      5.2.1 General
      5.2.2 Initial type testing of thermally strengthened
            soda lime silicate safety glass
      5.2.3 Initial type testing of characteristic's performances
  5.3 Factory production control and inspection of samples in
      accordance with a prescribed test plan
  5.4 Initial inspection of factory and of factory production
      control
  5.5 Continuous surveillance and assessment of the factory
      production control
6 Marking and/or labelling
  6.1 General
  6.2 Product marking
  6.3 Product characteristics
  6.4 'Characteristics/performance identification paper'
Annex A (normative) Factory production control
  A.1 Factory Production Control Requirements
      A.1.1 General
      A.1.2 Organisation
      A.1.3 Control system
  A.2 Marking
  A.3 Inspection and testing tables of chemically strengthened
      soda lime silicate safety glass production
      A.3.1 Information on Table A.1
      A.3.2 Use of proxy testing
Annex B (informative) Test for factory production control
  B.1 Strength Measurement
      B.1.1 Four point bending strength test
      B.1.2 Optical surface pre-stress measurement
  B.2 Fragmentation test
      B.2.1 Requirements
      B.2.2 Test method
Annex C (informative) Provisions for voluntary involvement of
                      third party(ies)
  C.1 General
  C.2 Voluntary tasks for third parties
  C.3 Marking and labelling
Annex ZA (informative) Clauses of this European Standard addressing
                       the provisions of EU Construction Products
                       Directive
  ZA.1 Scope and relevant characteristics
  ZA.2 Procedure(s) for the attestation of conformity of
       thermally toughened soda lime silicate safety glass
       products
       ZA.2.1 System(s) of attestation of conformity
       ZA.2.2 EC Certificate and Declaration of conformity
  ZA.3 CE marking and labelling
Bibliography

Describes the evaluation of conformity and the factory production control of flat thermally toughened soda lime silicate safety glass for use in buildings.

This document covers the evaluation of conformity and the factory production control of flat thermally toughened soda lime silicate safety glass for use in buildings. Note: For glass products with electrical wiring or connections for, e.g. alarm or heating purposes, other directives, e.g. Low Voltage Directive, may apply.