BS 969:2008
Current
The latest, up-to-date edition.
Specification for limits and tolerances on plain limit gauges
Hardcopy , PDF
English
08-31-2009
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Foreword
1 Scope
2 Terms and definitions
3 Gauge limits and tolerances
4 Hardness
5 Marking
6 Gauges in disagreement
Annexes
Annex A (informative) - Examples of the use of Table 1
Annex B (informative) - Principles of inspection using plain
limit gauges
Annex C (informative) - Values for gauges in imperial units
Bibliography
Defines tolerances and limits for simple forms of limit gauges, such as cylindrical plain plug, ring and gap gauges, for which gauge limits have not been stipulated.
| Committee |
TPR/1
|
| DevelopmentNote |
Supersedes BS 969(1982) and 08/30177723 DC. (11/2008)
|
| DocumentType |
Standard
|
| Pages |
18
|
| PublisherName |
British Standards Institution
|
| Status |
Current
|
| SupersededBy | |
| Supersedes |
This British Standard specifies tolerances and limits for simple forms of limit gauges, such as cylindrical plain plug, ring and gap gauges, for which gauge limits have not been stipulated.
It specifies gauge tolerances for workpiece tolerances in the range between 0.009 mm and 3.200 mm and how gauge limits are related to the workpiece limits. It also specifies types of gauge according to size and minimum workpiece tolerance.
NOTE Where a workpiece tolerance is outside the range 0.009 mm to 3.200 mm, or if it is not possible to conform to Table 2 regarding type of gauge, gauge tolerance and workpiece size, direct measurement should be used.
The gauge tolerances specified are such that the size of any workpiece accepted by a gauge lies within the boundaries constituted by the workpiece limits. Furthermore, the magnitude of the gauge tolerances is consequent upon the amount of the workpiece tolerance only. A wear allowance is provided on all GO gauges, i.e. those that control the maximum material condition of the workpiece.
| BS 1769:1951 | Specification. Unified black hexagon bolts, screws, nuts (UNC & UNF threads). Heavy series |
| BS 1726-1:2010 | Cylindrical helical springs made from round wire and bar. Guide to methods of specifying and tolerancing hot coiled springs, and cold coiled springs not covered by BS EN 15800, and general spring testing Compression springs |
| BS 1768:1963 | Specification for Unified precision hexagon bolts, screws, & nuts (UNC & UNF threads). Normal series |
| BS 1916-1:2009 | Limits and fits for engineering Guide to limits and tolerances |
| BS 1044-1:1964 | Specificaton for gauge blanks Plug, ring and calliper gauges |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.