BS 7629-2:1997
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Specification for 300/500 V fire resistant electric cables having low emission of smoke and corrosive gases when affected by fire. Multipair cables
Hardcopy , PDF
11-30-2008
English
04-29-2005
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Committees responsible
Foreword
1 Scope
2 Normative references
3 Terms and definitions
4 Voltage designation
5 Conductors and drain wire
6 Insulation
7 Formation and identification of pairs and quads
8 Laying-up
9 Screen
10 Sheath
11 Cable marking
12 Schedule of tests
13 Test conditions
14 Routine tests
15 Sample tests
16 Type tests
Annex A (informative) Recommendations for selection, operation
and installation of cables
Annex B (normative) Test for bending characteristics
Annex C (normative) Test for resistance to impact at ambient
temperature
Annex D (informative) Guidance for the selection of samples for
the manufacturer's demonstration of conformity
Annex E (normative) Additional provisions relating to cables
of a diameter exceeding 20 mm
Bibliography
Tables
Figures
Specifies requirements for construction and performance and describes methods of tests for cables with thermosetting insulation of rated voltage 300/500V.
| Committee |
GEL/20/17
|
| DevelopmentNote |
Supersedes 96/200299 DC & 02/208356 DC Together with BS 7629-1(1997) it supersedes BS 7629(1993) (02/2004) Reviewed and Confirmed by BSI, August 2007. (07/2007)
|
| DocumentType |
Standard
|
| Pages |
22
|
| PublisherName |
British Standards Institution
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
| BS 5266-1:2005 | Emergency lighting Code of practice for the emergency lighting of premises |
| PD 6686:2006 | Guidance on directives, regulations and standards related to prevention of fire and explosion in the process industries |
| 05/30124836 DC : DRAFT JULY 2005 | BS 5266-1 - EMERGENCY LIGHTING - PART 1: CODE OF PRACTICE FOR THE EMERGENCY LIGHTING OF PREMISES |
| BS 5839-8:1998 | Fire detection and fire alarm systems for buildings Code of practice for the design, installation, commissioning, and maintenance of voice alarm systems |
| 01/540647 DC : DRAFT MAY 2001 | BS 5839-1 - FIRE DETECTION AND ALARM SYSTEMS FOR BUILDINGS - PART 1 - CODE OF PRACTICE FOR SYSTEM DESIGN, INSTALLATION AND MAINTENANCE |
| BS 7655-6.1(1994) : 1994 | SPECIFICATION FOR INSULATING AND SHEATHING MATERIALS FOR CABLES - THERMOPLASTIC SHEATHING COMPOUNDS HAVING LOW EMISSION OF CORROSIVE GASES, AND SUITABLE FOR USE IN CABLES HAVING LOW EMISSION OF SMOKE WHEN AFFECTED BY FIRE - GENERAL APPLICATION THERMOPLASTIC TYPES |
| BS 4727-2:GRP08(1994) : 1994 | GLOSSARY OF ELECTROTECHNICAL, POWER, TELECOMMUNICATION, ELECTRONICS, LIGHTING AND COLOUR TERMS - TERMS PARTICULAR TO POWER ENGINEERING - ELECTRIC CABLES |
| BS EN 50268-2:2000 | Common test methods for cables under fire conditions. Measurement of smoke density of cables burning under defined conditions Procedure |
| BS 5839-1:1988 | Fire detection and alarm systems for buildings Code of practice for system design, installation and servicing |
| BS EN 50267-2-1:1999 | Common test methods for cables under fire conditions. Tests on gases evolved during combustion of materials from cables. Procedures Determination of the amount of halogen acid gas - Determination of the amount of halogen acid gas |
| BS EN 60811-1-1:1995 | Insulating and sheathing materials of electric cables. Common test methods. General application Measurement of thickness and overall dimensions. Tests for determining the mechanical properties - Section 1: Measurement of thickness and overall dimensions - Tests for determining the mechanical properties |
| BS EN 60811-3-1:1995 | Insulating and sheathing materials of electric cables. Common test methods. Methods specific to PVC compounds Pressure test at high temperature. Tests for resistance to cracking |
| BS 7655-1.1(1993) : 1993 | INSULATING AND SHEATHING MATERIALS FOR CABLES - ELASTOMERIC INSULATING COMPOUNDS - HARMONIZED TYPES |
| BS EN 50265-2-1:1999 | Common test methods for cables under fire conditions. Test for resistance to vertical flame propagation for a single insulated conductor or cable. Procedures 1 kW pre-mixed flame - 1 kW pre-mixed flame |
| BS 7655-5.1(1994) : 1994 | SPECIFICATION FOR INSULATING AND SHEATHING MATERIALS FOR CABLES - CROSS LINKED INSULATING COMPOUNDS HAVING LOW EMISSION OF CORROSIVE GASES, AND SUITABLE FOR USE IN CABLES HAVING LOW EMISSION OF SMOKE WHEN AFFECTED BY FIRE - HARMONIZED CROSS LINKED TYPES |
| BS EN 60811-1-4:1995 | Insulating and sheathing materials of electric cables. Common test methods. General application Tests at low temperature |
| BS 7655-1.2(1993) : 1993 | INSULATING AND SHEATHING MATERIALS FOR CABLES - ELASTOMERIC INSULATING COMPOUNDS - GENERAL 90 DEGREE C APPLICATION |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.