BS 7270:2006
Current
The latest, up-to-date edition.
Metallic materials. Constant amplitude strain controlled axial fatigue. Method of test
Hardcopy , PDF
English
12-29-2006
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Foreword
1 Scope
2 Normative references
3 Terms and definitions
4 Symbols
5 Principle
6 Test equipment and environment
7 Specimen geometry
8 Alignment of test fixtures
9 Test procedure
10 Test report
Annexes
Annex A (informative) Generation of data sets
Annex B (informative) Test fixtures
Annex C (normative) Dynamic verification of extensometry
Annex D (normative) Specimen preparation
Annex E (normative) Verification of alignment of the
load train
Bibliography
Specifies a method of cyclically loading a metallic specimen under strain control between set strain limits to determine its fatigue resistance.
| Committee |
ISE/101/6
|
| DevelopmentNote |
Supersedes BS 7270(1990) and 01/716136 DC (12/2006)
|
| DocumentType |
Standard
|
| Pages |
28
|
| PublisherName |
British Standards Institution
|
| Status |
Current
|
| Supersedes |
This British Standard describes a method of cyclically loading a metallic specimen under strain control between set strain limits to determine its fatigue resistance. The fatigue resistance is measured in terms of cycles to failure as a function of the applied strain range and the associated variations in stress range, mean stress and plastic strain range. The method is restricted to uniaxially loaded parallel section specimens tested in air at ambient temperature and to metals where time-dependent deformation can be ignored. The method is applicable to both high- and low-cycle fatigue tests.
NOTE 1 Advice on the generation of data sets from individual specimen results determined using this method is given in Annex A.
NOTE 2 Users should assure themselves that the test conditions used and the specimen orientation are relevant to their application.
| BS EN ISO 9513:2012 | Metallic materials. Calibration of extensometer systems used in uniaxial testing |
| BS EN ISO 7500-1:2015 | Metallic materials. Calibration and verification of static uniaxial testing machines Part 1: Tension/compression testing machines. Calibration and verification of the force-measuring system |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.