BS 4979-1:1973
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Methods for testing and rating air control devices for air distribution systems Aerodynamic testing of constant flow rate assemblies without a heat exchanger
Hardcopy
07-23-2013
English
08-29-1975
Important note : All end users must be registered with an Account prior to user licenses being assigned.Deals with constant flow rate controller characteristics, the performance of the proportioning damper fitted to a dual duct box and the degree of temperature mixing achieved by this latter, as well as with casing leakage. Both single and dual boxes are covered, also single duct units.
| Committee |
RHE/2
|
| DocumentType |
Standard
|
| Pages |
0
|
| PublisherName |
British Standards Institution
|
| Status |
Superseded
|
| SupersededBy |
| BS 1042-1.1(1981) : 1981 | MEASUREMENT OF FLUID FLOW IN CLOSED CONDUITS - SPECIFICATION FOR SQUARE-EDGED ORIFICE PLATES, NOZZLES AND VENTURI TUBES INSERTED IN CIRCULAR CROSS SECTION CONDUITS RUNNING FULL |
| BS 1042-1.5(1987) : 1987 | MEASUREMENTS OF FLUID FLOW IN CLOSED CONDUITS - GUIDE TO THE EFFECT OF DEPARTURE FROM THE STANDARD CONDITIONS SPECIFIED IN SECTION 1.1 |
| BS 1042-2.3:1984 | Measurement of fluid flow in closed conduits. Velocity area methods Methods of flow measurement in swirling or asymmetric flow conditions in circular ducts by means of current-meters or Pitot static tubes |
| BS 1042-2.2:1983 | Measurement of fluid flow in closed conduits. Velocity area methods Method of measurement of velocity at one point of a conduit of circular cross section |
| BS 1042-2.1:1983 | Measurement of fluid flow in closed conduits. Velocity area methods Method using Pitot static tubes |
| BS 1042-1.2(1984) : LATEST | SPEC. FOR SQUARE-EDGED ORIFICE PLATES, NOZZLES (WITH DRAIN HOLES, IN PIPES BELOW 50MM DIAMETER, AS INLET AND OUTLET DEVICES) AND OTHER ORIFICE PLATES AND BORDA INLETS |
| BS 4773-1:1971 | Methods for testing and rating air terminal devices for air distribution systems Aerodynamic testing |
| BS 1042-1.4(1984) : 1984 | MEASUREMENT OF FLUID FLOW IN CLOSED CONDUITS - GUIDE TO THE USE OF DEVICES SPECIFIED IN SECTIONS 1.1 AND 1.2 |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.