BS 4062-2:1990
Current
The latest, up-to-date edition.
Valves for hydraulic fluid power systems Methods for determining performance
Hardcopy , PDF
English
06-29-1990
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Committees responsible
National foreword
0 Introduction
1 Scope and field of application
2 References
3 Definitions
4 Symbols and units
5 Test installation - General requirements
6 General test conditions
7 Test procedure for directional control valves
8 Test procedure for non-return (check) valves
9 Test procedure for valves controlling pressure
10 Test procedure for flow control valves
11 Test procedure for flow-dividing valves
12 Test report
13 Identification statement
Annex A - Classes of measurement accuracy
Annex B - Use for practical units
Publications referred to
Methods of testing 4 types of hydraulic fluid power valve to determine their steady state and dynamic performance. Gives requirements for test installations and procedures, measurements and presentation of results. Appendices cover classes of measurement and use of practical units.
| Committee |
MCE/18
|
| DevelopmentNote |
Reviewed and confirmed by BSI, May, 2005. (04/2005) Also numbered as ISO 6403 Supersedes 85/79297 DC and BS 4062-2(1982) (07/2005)
|
| DocumentType |
Standard
|
| Pages |
36
|
| PublisherName |
British Standards Institution
|
| Status |
Current
|
| Supersedes |
This International Standard specifies methods for testing hydraulic valves which are used for the control of flow or pressure in a circuit in order to determine their steady-state and dynamic performance.
Requirements for test installations and procedures, measurements and presentation of results are specified. This International Standard does not establish limits of performance since the suitability of the valve for its intended purpose should be agreed between the manufacturer and the user.
Accuracy of measurement is divided into three classes (A, B and C) which are explained in Annex A. Guidance as to the use of practical units for the presentation of results is given in Annex B.
Proportional control valves are not dealt with in this International Standard. Electrohydraulic servovalves are dealt with in ISO 6404.
| ISO 4411:2008 | Hydraulic fluid power Valves Determination of pressure differential/flow characteristics |
| ISO 5598:2008 | Fluid power systems and components Vocabulary |
| BS 4062-1:1982 | Valves for hydraulic fluid power systems Methods for determining pressure differential/flow characteristics |
| ISO 1219:1976 | Fluid power systems and components — Graphic symbols |
| IEC 60085:2007 | Electrical insulation - Thermal evaluation and designation |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.