BIS IS 12640-1 : 2008
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
RESIDUAL CURRENT OPERATED CIRCUIT-BREAKERS FOR HOUSEHOLD AND SIMILAR USES - PART 1: CIRCUIT-BREAKERS WITHOUT INTEGRAL OVERCURRENT PROTECTION (RCCBS)
09-19-2024
01-12-2013
NATIONAL FOREWORD
1 Scope
2 Normative references
3 Definitions
4 Classification
5 Characteristics of RCCBs
6 Marking and other product information
7 Standard conditions for operation in service and
for installation
8 Requirements for construction and operation
9 Tests
Annex A (normative) - Test sequence and number of
samples to be submitted for certification
purposes
Annex B (normative) - Determination of clearances and
creepage distances
Annex C (normative) - Arrangement for the detection of
the emission of ionized gases during short-circuit
tests
Annex D (normative) - Routine tests
Annex IA (informative) - Methods for determination of
short-circuit power-factor
Annex IB (informative) - Glossary of symbols
Annex IC (informative) - Examples of terminal designs
Annex ID (informative) - Correspondence between ISO
and AWG copper conductors
Annex IE (informative) - Follow-up testing program for
RCCBs
Annex IF (informative) - SCPDs for short-circuit tests
Deals with residual current operated circuit-breakers functionally independent of, or functionally dependent on, line voltage, for household and similar uses, not incorporating overcurrent protection (hereafter referred to as RCCBs), for rated voltages not exceeding 440 V a.c. and rated currents not exceeding 125 A, intended principally for protection against shock-hazard.
| Committee |
ETD 7
|
| DocumentType |
Standard
|
| PublisherName |
Bureau of Indian Standards
|
| Status |
Superseded
|
| SupersededBy |
| BIS SP 72 : 2010(R2014) | NATIONAL LIGHTING CODE 2010 |
| BIS IS/IEC 60947-2 : 2003 | LOW-VOLTAGE SWITCHGEAR AND CONTROLGEAR - PART 2: CIRCUIT BREAKERS |
| BIS IS 12640-2 : 2008 | RESIDUAL CURRENT OPERATED CIRCUIT-BREAKING FOR HOUSEHOLD AND SIMILAR USES - PART 2: CIRCUIT-BREAKERS WITH INTEGRAL OVERCURRENT PROTECTION (RCBOS) |
| BIS IS 15787 : 2008 | SWITCH-SOCKET-OUTLETS (NON-INTERLOCK TYPE) |
| IEC 60112:2003+AMD1:2009 CSV | Method for the determination of the proof and the comparative tracking indices of solid insulating materials |
| IEC 60060-2:2010 | High-voltage test techniques - Part 2: Measuring systems |
| IEC 60038:2009 | IEC standard voltages |
| BIS IS 12063 : 1987(R2004) | CLASSIFICATION OF DEGREES OF PROTECTION PROVIDED BY ENCLOSURES OF ELECTRICAL EQUIPMENT |
| BIS IS 1885-74 : 2012(R2017) | ELECTROTECHNICAL VOCABULARY - PART 74: ELECTRICAL AND MAGNETIC DEVICES |
| BIS IS 2071-1 : 2016 | HIGH-VOLTAGE TEST TECHNIQUES - PART 1: GENERAL DEFINITIONS AND TEST REQUIREMENTS |
| IEC 60050-151:2001 | International Electrotechnical Vocabulary (IEV) - Part 151: Electrical and magnetic devices |
| IEC 60884-1:2002+AMD1:2006+AMD2:2013 CSV | Plugs and socket-outlets for household and similar purposes - Part1: General requirements |
| IEC 60050-441:1984 | International Electrotechnical Vocabulary (IEV) - Part 441: Switchgear, controlgear and fuses |
| IEC 60364-5-53:2001+AMD1:2002+AMD2:2015 CSV | Electrical installations of buildings - Part 5-53: Selection and erection of electrical equipment - Isolation, switching and control |
| BIS SP 30 : 2011(R2016) | NATIONAL ELECTRICAL CODE |
| BIS IS 9000-5-1&2 : 1981(R2004) | BASIC ENVIRONMENTAL TESTING PROCEDURES FOR ELECTRONIC AND ELECTRICAL ITEMS - PART 5: DAMP HEAT (CYCLIC) TEST |
| BIS IS 12360 : 1988(R2015) | VOLTAGE BANDS FOR ELECTRICAL INSTALLATIONS INCLUDING PREFERRED VOLTAGES AND FREQUENCY |
| IEC 60695-2-10:2000 | FIRE HAZARD TESTING - TEST METHODS - GLOW-WIRE TEST METHODS - GENERAL |
| BIS IS 2071-3 : 1976(R2006) | METHODS OF HIGH VOLTAGE TESTING - PART 3: MEASURING DEVICES |
| IEC 60529:1989+AMD1:1999+AMD2:2013 CSV | Degrees of protection provided by enclosures (IP Code) |
| IEC 60755:2017 | General safety requirements for residual current operated protective devices |
| BIS IS 1885-17 : 1979(R2017) | ELECTROTECHNICAL VOCABULARY - PART 17: SWITCHGEAR AND CONTROLGEAR |
| BIS IS 15382-1 : 2014 | INSULATION COORDINATION FOR EQUIPMENT WITHIN LOW-VOLTAGE SYSTEMS - PART 1: PRINCIPLES, REQUIREMENTS AND TESTS |
| IEC 60364-4-443:1995+AMD1:1998 CSV | Electrical installations of buildings - Part 4: Protection for safety - Chapter 44: Protection against overvoltages - Section 443: Protection against overvoltages of atmospheric origin or due to switching |
| IEC 60051:1973 | Recommendations for direct acting indicating electrical measuring instruments and their accessories |
| BIS IS 12640-2 : 2008 | RESIDUAL CURRENT OPERATED CIRCUIT-BREAKING FOR HOUSEHOLD AND SIMILAR USES - PART 2: CIRCUIT-BREAKERS WITH INTEGRAL OVERCURRENT PROTECTION (RCBOS) |
| IEC 60068-2-28:1990 | Environmental testing - Part 2: Tests. Guidance for damp heat tests |
| BIS IS 2824 : 2007 | METHOD FOR THE DETERMINATION OF THE PROOF AND THE COMPARATIVE TRACKING INDICES OF SOLID INSULATING MATERIALS |
| IEC 60060-1:2010 | High-voltage test techniques - Part 1: General definitions and test requirements |
| BIS IS 1248-1 : 2003 | DIRECT ACTING INDICATING ANALOGUE ELECTRICAL MEASURING INSTRUMENTS AND THEIR ACCESSORIES - SPECIFICATION - PART 1: DEFINITIONS AND GENERAL REQUIREMENTS |
| IEC 60664-1:2007 | Insulation coordination for equipment within low-voltage systems - Part 1: Principles, requirements and tests |
| IEC 60068-2-30:2005 | Environmental testing - Part 2-30: Tests - Test Db: Damp heat, cyclic (12 h + 12 h cycle) |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.