ASTM E 1363 : 2003
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Standard Test Method for Temperature Calibration of Thermomechanical Analyzers
Hardcopy , PDF
11-11-2014
English
03-10-2003
Important note : All end users must be registered with an Account prior to user licenses being assigned.| Committee |
E 37
|
| DocumentType |
Test Method
|
| Pages |
5
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
1.1 This test method describes the temperature calibration of thermomechanical analyzers from -50 to 1100°C. (See Note 2.)
1.2 Computer or electronic based instruments, techniques, or data treatment equivalent to this test method may be used. Note 2Users of this test method are advised that all such instruments or techniques may not be equivalent. It is the responsibility of the user of this test method to determine the necessary equivalency prior to use.
1.3 SI units are the standard.
1.4 This standard is similar to ISO 11359-1 but addresses a larger temperature range and utilizes additional calibration materials.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific precautionary statements are given in Section 7 and Note 10.
| ASTM E 2113 : 2018 | Standard Test Method for Length Change Calibration of Thermomechanical Analyzers |
| ASTM E 2092 : 2018 : REV A | Standard Test Method for Distortion Temperature in Three-Point Bending by Thermomechanical Analysis |
| ASTM E 2347 : 2016 | Standard Test Method for Indentation Softening Temperature by Thermomechanical Analysis |
| ASTM E 3142 : 2018 : REV A | Standard Test Method for Thermal Lag of Thermal Analysis Apparatus |
| ASTM E 2918 : 2018 : REV A | Standard Test Method for Performance Validation of Thermomechanical Analyzers |
| ASTM E 1545 : 2011 : R2016 | Standard Test Method for Assignment of the Glass Transition Temperature by Thermomechanical Analysis |
| ASTM E 2206 : 2011 : R2015 | Standard Test Method for Force Calibration of Thermomechanical Analyzers |
| ASTM E 1640 : 2018 | Standard Test Method for Assignment of the Glass Transition Temperature By Dynamic Mechanical Analysis |
| ASTM E 831 : 2019 | Standard Test Method for Linear Thermal Expansion of Solid Materials by Thermomechanical Analysis |
| ASTM E 2769 : 2018 | Standard Test Method for Elastic Modulus by Thermomechanical Analysis Using Three-Point Bending and Controlled Rate of Loading |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.