ASTM E 1247 : 2012
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Standard Practice for Detecting Fluorescence in Object-Color Specimens by Spectrophotometry
Hardcopy , PDF
11-26-2023
English
07-01-2012
Important note : All end users must be registered with an Account prior to user licenses being assigned.CONTAINED IN VOL. 06.01, 2017 Gives spectrophotometric methods for detecting the presence of fluorescence in object-color specimens.
| Committee |
E 12
|
| DocumentType |
Standard Practice
|
| Pages |
4
|
| ProductNote |
Reconfirmed 2012
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
1.1 This practice provides spectrophotometric methods for detecting the presence of fluorescence in object-color specimens.
Note 1—Since the addition of fluorescing agents (colorants, whitening agents, etc.) is often intentional by the manufacturer of a material, information on the presence or absence of fluorescent properties in a specimen may often be obtained from the maker of the material.
1.2 This practice requires the use of a spectrophotometer that both irradiates the specimen over the wavelength range from 340 to 700 nm and allows the spectral distribution of illumination on the specimen to be altered as desired.
1.3 Within the above limitations, this practice is general in scope rather than specific as to instrument or material.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
| ASTM E 991 : 2016 | Standard Practice for Color Measurement of Fluorescent Specimens Using the One-Monochromator Method |
| ASTM E 805 : 2012 : REV A : R2017 | Standard Practice for Identification of Instrumental Methods of Color or Color-Difference Measurement of Materials |
| ASTM E 313 : 2015 : EDT 1 | Standard Practice for Calculating Yellowness and Whiteness Indices from Instrumentally Measured Color Coordinates |
| ASTM D 4956 : 2019 | Standard Specification for Retroreflective Sheeting for Traffic Control |
| ASTM D 2805 : 2011 : R2018 | Standard Test Method for Hiding Power of Paints by Reflectometry |
| ASTM D 5382 : 2002 : R2017 | Standard Guide to Evaluation of Optical Properties of Powder Coatings |
| ASTM E 284 : 2017 : REDLINE | Standard Terminology of Appearance |
| ASTM D 2244 : 2016 : REDLINE | Standard Practice for Calculation of Color Tolerances and Color Differences from Instrumentally Measured Color Coordinates |
| ASTM E 991 : 2016 : REDLINE | Standard Practice for Color Measurement of Fluorescent Specimens Using the One-Monochromator Method |
| ASTM E 1331 : 2015 : REDLINE | Standard Test Method for Reflectance Factor and Color by Spectrophotometry Using Hemispherical Geometry |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.