ASTM E 1181 : 2002
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Standard Test Methods for Characterizing Duplex Grain Sizes
Hardcopy , PDF
11-11-2014
English
04-10-2002
Important note : All end users must be registered with an Account prior to user licenses being assigned.CONTAINED IN VOL. 03.01, 2015 Gives simple guidelines for deciding whether a duplex grain size exists.
| Committee |
E 04
|
| DevelopmentNote |
Supersedes SAE AMS 2316. (10/2004)
|
| DocumentType |
Test Method
|
| Pages |
15
|
| ProductNote |
Reconfirmed 2002
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
1.1 These test methods provide simple guidelines for deciding whether a duplex grain size exists. The test methods separate duplex grain sizes into one of two distinct classes, then into specific types within those classes, and provide systems for grain size characterization of each type.
1.2 This standard may involve hazardous materials, operations, and equipment. This standard does not purport to address all of the safety concerns associated with its use. It is the responsibility of the user of this standard to consult appropriate safety and health practices and determine the applicability of regulatory limitations prior to its use.
| ASTM E 930 : 2018 | Standard Test Methods for Estimating the Largest Grain Observed in a Metallographic Section (ALA Grain Size) |
| ASTM E 2627 : 2013 | Standard Practice for Determining Average Grain Size Using Electron Backscatter Diffraction (EBSD) in Fully Recrystallized Polycrystalline Materials |
| ASTM E 112 : 2013 | Standard Test Methods for Determining Average Grain Size |
| ASTM E 1382 : 1997 : R2015 | Standard Test Methods for Determining Average Grain Size Using Semiautomatic and Automatic Image Analysis |
| ASTM G 133 : 2005 : R2016 | Standard Test Method for Linearly Reciprocating Ball-on-Flat Sliding Wear |
| ASTM E 7 : 2017 : REDLINE | Standard Terminology Relating to Metallography |
| ASTM E 562 : 2011 : REDLINE | Standard Test Method for Determining Volume Fraction by Systematic Manual Point Count |
| ASTM E 930 : 1999 | Standard Test Methods for Estimating the Largest Grain Observed in a Metallographic Section (ALA Grain Size) |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.