ASTM E 1040 : 2010 : R2016
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Standard Specification for Physical Characteristics of Nonconcentrator Terrestrial Photovoltaic Reference Cells
Hardcopy , PDF
09-11-2020
English
07-01-2016
Important note : All end users must be registered with an Account prior to user licenses being assigned.CONTAINED IN VOL. 12.02, 2018 Specifies the physical requirements for primary and secondary terrestrial nonconcentrator photovoltaic reference cells.
| Committee |
E 44
|
| DocumentType |
Standard
|
| Pages |
3
|
| ProductNote |
Reconfirmed 2016
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
1.1This specification describes the physical requirements for primary and secondary terrestrial nonconcentrator photovoltaic reference cells. A reference cell is defined as a device that meets the requirements of this specification and is calibrated in accordance with Test Method E1125 or Test Method E1362.
1.2Reference cells are used in the determination of the electrical performance of photovoltaic devices, as stated in Test Methods E948 and E1036.
1.3Two reference cell physical specifications are described:
1.3.1Small-Cell Package Design—A small, durable package with a low thermal mass, wide optical field-of-view, and standardized dimensions intended for photovoltaic devices up to 20 by 20 mm, and
1.3.2Module-Package Design—A package intended to simulate the optical and thermal properties of a photovoltaic module design, but electric connections are made to only one photovoltaic cell in order to eliminate problems with calibrating series and parallel connections of cells. Physical dimensions are not standardized.
1.4The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.5This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
| ASTM E 1125 : 2016 | Standard Test Method for Calibration of Primary Non-Concentrator Terrestrial Photovoltaic Reference Cells Using a Tabular Spectrum |
| ASTM E 2236 : 2010 : R2019 | Standard Test Methods for Measurement of Electrical Performance and Spectral Response of Nonconcentrator Multijunction Photovoltaic Cells and Modules |
| ASTM E 1328 : 2005 | Standard Terminology Relating to Photovoltaic Solar Energy Conversion (Withdrawn 2012) |
| ASTM E 1036 : 2015 : R2019 | Standard Test Methods for Electrical Performance of Nonconcentrator Terrestrial Photovoltaic Modules and Arrays Using Reference Cells |
| ASTM E 1036 : 2015 | Standard Test Methods for Electrical Performance of Nonconcentrator Terrestrial Photovoltaic Modules and Arrays Using Reference Cells |
| ASTM E 1328 : 1999 | Standard Terminology Relating to Photovoltaic Solar Energy Conversion |
| ASTM E 1036 : 2008 | Standard Test Methods for Electrical Performance of Nonconcentrator Terrestrial Photovoltaic Modules and Arrays Using Reference Cells |
| ASTM E 1362 : 2015 | Standard Test Methods for Calibration of Non-Concentrator Photovoltaic Non-Primary Reference Cells |
| ASTM E 1125 : 2010 : R2015 | Standard Test Method for Calibration of Primary Non-Concentrator Terrestrial Photovoltaic Reference Cells Using a Tabular Spectrum |
| ASTM E 1125 : 2016 | Standard Test Method for Calibration of Primary Non-Concentrator Terrestrial Photovoltaic Reference Cells Using a Tabular Spectrum |
| ASTM E 1036 : 2012 | Standard Test Methods for Electrical Performance of Nonconcentrator Terrestrial Photovoltaic Modules and Arrays Using Reference Cells |
| ASTM E 1362 : 1999 | Standard Test Method for Calibration of Non-Concentrator Photovoltaic Secondary Reference Cells |
| ASTM E 772 : 2015 : REDLINE | Standard Terminology of Solar Energy Conversion |
| ASTM E 1125 : 2005 | Standard Test Method for Calibration of Primary Non-Concentrator Terrestrial Photovoltaic Reference Cells Using a Tabular Spectrum |
| MS3106 Revision D:1992 | CONNECTOR, PLUG, ELECTRIC, STRAIGHT, SOLDER CONTACTS, AN TYPE |
| ASTM E 1125 : 2010 | Standard Test Method for Calibration of Primary Non-Concentrator Terrestrial Photovoltaic Reference Cells Using a Tabular Spectrum |
| ASTM E 1362 : 2005 | Standard Test Method for Calibration of Non-Concentrator Photovoltaic Secondary Reference Cells |
| ASTM E 1362 : 2015 : R2019 | Standard Test Methods for Calibration of Non-Concentrator Photovoltaic Non-Primary Reference Cells |
| ASTM E 1036 : 2002 : R2007 | Standard Test Methods for Electrical Performance of Nonconcentrator Terrestrial Photovoltaic Modules and Arrays Using Reference Cells |
| ASTM E 1362 : 2010 | Standard Test Method for Calibration of Non-Concentrator Photovoltaic Secondary Reference Cells |
| ASTM E 1125 : 2016 : REDLINE | Standard Test Method for Calibration of Primary Non-Concentrator Terrestrial Photovoltaic Reference Cells Using a Tabular Spectrum |
| ASTM E 1328 : 2003 | Standard Terminology Relating to Photovoltaic Solar Energy Conversion |
| ASTM E 1036 : 2002 | Standard Test Methods for Electrical Performance of Nonconcentrator Terrestrial Photovoltaic Modules and Arrays Using Reference Cells |
| ASTM E 1125 : 1999 | Standard Test Method for Calibration of Primary Non-Concentrator Terrestrial Photovoltaic Reference Cells Using a Tabular Spectrum |
| ASTM E 948 : 2016 : REDLINE | Standard Test Method for Electrical Performance of Photovoltaic Cells Using Reference Cells Under Simulated Sunlight |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.